AGFA d-lab.3 Digital Compact Lab

Printer
Repair
Replacing the Motor SG_MO02
Replacement required:
If the motor is defective, the rocker does not move
any more.
Allan key 2,5
Removal:
− Open the circlip (on coupling .SGAS)
− Unscrew the motor through the holes in the
holding plate
− Remove the motor with the code disk and the
crank
− Dismount the motor, the code disk and the crank
Installation:
− Installation in reverse order
− The parts cannot be mixed up when they are
mounted.
The slide bearings between the crank and the
coupling must point to the inside to the motor!
Replacing the toothed Belt
Replacement required:
Toothed belt torn or damaged
Allan key 3,0 angled
Ball head screwdriver 3,0
Dynamometer
− Unscrew the motor SG_MO01 so that the belt
tension slackens
− Change the belt and screw down the motor
Measure the belt tension with the dynamometer:
1,0 N
6.4.20 2001-01-02 /PN 9009 AGFA d-lab.3