AGFA d-lab.3 Digital Compact Lab

Repair
Printer
Replacing the Motor SG_MO01
Replacement required:
If the motor is defective, the paper does not pass
any more through the SG.
The motor can only be replaced together with the
sync disk.
Allan key 2,0
Allan key 3,0 angled
Ball head screwdriver 3,0
Dynamometer
Removal:
− Unscrew the .SGAJ cover:
3 Allan screws 2,0
− Cut the cable ties and unscrew the motor
Installation:
− Adjust the correct belt tension by shifting the
motor
− Screw on the motor very tight, using the angled
screwdriver!
Caution!
When mounting the .SGAJ cover, make sure that a
lock washer and a washer are used on each screw.
If this is not done, the screw may damage the cable.
Measure the belt tension with the dynamometer:
1,0 N
AGFA d-lab.3 2001-01-02 /PN 9009 6.4.19