AGFA d-lab.3 Digital Compact Lab

Repair
Printer
Transmit software and setup values to the
Printer Mainboard (in this sequence)
− Switch on voltages:
Switch on d-lab, or execute the script Script
for service/initialisation/
start_up_d-lab.txt
Check the software on the Printer Mainboard
The following software elements are stored on the
Printer Mainboard, and in case of PCB replacement
they must be updated:
− Firmware Printer Mainboard (prhp.hex)
− Firmware XILINXS (prxi.hex)
− And further:
Firmware Printer – Bootloader (bl.hex).
This file is not replaced during the update.
− SETUP parameters of the Printer assemblies
On spare PCBs from stock there is usually an
unknown firmware version (also see Important
note, next page).
The setup values do not correspond either to the
repaired machine. (Usually default values)
Therefore a software check for the new Printer
Mainboard must be made:
− Check via Service / Firmware Version.
− Compare the displayed result with the required
version of the software package present in the
machine:
The firmware belonging to a certain software
package can be determined subsequently.
− Activate the Windows Explorer (via Watchdog)
− Open the file label.txt. Path:
C:\SoftwareVersion/PR/Install/
PR_Vxxx-y/label.txt
Information from Label.txt:
Here HP stands for prhp.hex and XI for prxi.hex
AGFA d-lab.3 2001-01-02 /PN 9009 6.4.5