AGFA d-lab.3 Digital Compact Lab

Repair
Printer
LED Display
The contacts on ST25 must be plugged in
(= LED enable)
The status is displayed when the assembly group
is initialised (from left to right).
Power ok
Reset
BOP
SV-SPI
Lights when the supply voltages 24V, 36V and 5V on Power GND are ok
Lights when the Reset line on the SPI Interface is active
Lights when no paper is in front of the BOP sensor on the print roller (result of the
assessment of the frequency f_BOP)
Lights when the logic supply 5V of the logic source voltage 6,5V is ensured via the SPI
interface
Test Points
MP1 +5V +5V logic supply of the 6,5V via the SPI Interface
MP2 GND GND against +5V
MP4 Steps Stepper motor clocks for the actuator of the flap control
MP6 P5V Master frequency for the polygonal drive 1,399kHz
MP7 P5V Logic supply 5V derived from 36V
MP8 PGND GND against P5V
MP9 — not used
MP10 BOP BOP-Signal: low when no paper in front of the sensor
MP11 BOL BOL-Signal: positive pulse of approx. 33µs always at the beginning of the line
Connector Assignment
see PE_GS01, connector assignment in
register 6.2
AGFA d-lab.3 2001-01-02 /PN 9009 6.3.43