AGFA d-lab.3 Digital Compact Lab

Repair
Printer
Paper Magazine Coding
Slide closed
■ Slide open
PATTERN
PAPER SIZE
1 2 3 4 5 6
3.25 inch (82 mm) • •
3.50 inch (89 mm) • • •
3.75 inch (95 mm) • • •
4.00 inch (102 mm) • • •
4.75 inch (120 mm) • • • GLOSSY •
5.00 inch (127 mm) • • MATTE ••
6.00 inch (152 mm) • CUSTOM1 •
6.50 inch (165 mm) • • CUSTOM2
7.00 inch (178 mm) • •
8.00 inch (203 mm) • •
8.25 inch (210 mm) •
Magazine Drive, Functional Assembly Groups
− Sensor signal for the measuring length (PSG,
NSG): It is sent directly by the SPI module sheet
gear SG_GS01 and defines the
distances between two sensors for which a step
number is defined. This step number is made
available for the calculation of the winding core.
− Magazine Lock that holds the magazine and
sends a signal via LS08 when a magazine has
been put in.
− The magazine change indication informs the
operator when to change a magazine. LED_RT
active = magazine change not allowed!
− The Shutter assembly group is mechanically
coupled to the magazine and sends a signal via
LS07 when paper has been transported out of
the magazine.
− The magazine coding encompasses the
reflected light sensors LS01 to LS06. These
sensors are used to detect the paper type and
the format after the magazine has been put in.
The format is set by the mechanical slides on the
magazine.
− Drive of the magazine core: The motor MO02 is
driven directly by the AVR Controller. It is
responsible for the formation of a paper loop in
the magazine. The loop must be large enough so
that a maximum paper size can be supplied
quickly and at any time by motor1.
AGFA d-lab.3 2001-01-02 /PN 9009 6.3.27