AGFA d-lab.3 Digital Compact Lab

Printer
Repair
ST 26: CAN – Interface
PIN Signal name Comment I/O
1 GND Reference potential GND O
2 CANH CAN – HIGH I/O
3 CANL CAN – LOW I/O
4 GND Reference potential GND O
The connectors ST 21, ST 22,ST 24 and ST 28
have no significance.
Their use does not make sense at present.
ST 31: ISP– Programming connector
PIN Signal name Comment I/O
1 ISPCLK Programming clock O
2 MODE Mode line O
3 ISPDI Prog. data O
4 ISPSDO Read data O
5 ISPEN Enable O
6 ISPRES Reset O
7 + 5 Operating voltage +5 V I
8 GND Reference potential GND I
Jumper Assignment and LED
D 1 = LED_ROT >
Lights when an SPI module has logged in an
Interrupt
J 1 = nc
J 2 = nc
J 4 = nc
J 5 = nc
J 6 = plugged in
ISPEN is passive
Vacant
Not plugged in, CPU works in
normal mode
All displays are passive
CAN termination resistance
active
Test Points
MP 3
MP 4
MP 23
= +5 V
= GND
= Not used (no significance)
6.2.16 2001-01-02 /PN 9009 AGFA d-lab.3