AGFA d-lab.3 Digital Compact Lab

Printer
Repair
Voltages on the d-lab.3
24 V switchable measurable Voltage for Printer and Scanner
(switched together !)
36 V switchable measurable Voltage for Printer and Scanner
(switched together!)
28 V not switchable measurable AOM – voltage
22,8
V
switchable and
interruptible on
primary side by
Interlock switch
measurable
Scanner lamp voltage
5 V not switchable measurable Scanner – Microcontroller voltage
± 15
V
not switchable measurable Scanner and red Laser diode
(switched together!)
6,5 V not switchable measurable 5 V Printer – Microcontroller voltage
± 9 V not switchable measurable Analogue voltage
Laser Remote
input
(switchable)
Laser Remote
input
(switchable)
can be
checked via
SPI Power
module
can be
checked via
SPI Power
module
Unloading circuit on the Laser:
− after switch-on approx. 20 min until a stable status is
reached
− after switch-off approx. 5 min for the fan afterrun
Circuit of the Standby mode:
− after activation and switch-back approx. 3 min until a
stable status is reached
Available test points result from the descriptions
of the individual printed circuits.
see Register 6.3
6.1.6 2001-01-02 /PN 9009 AGFA d-lab.3