AGFA d-lab.3 Digital Compact Lab

Scanner
Repair
Bus Systems and Interfaces
CAN Bus
The CAN Bus is used for the internal
communication of the Scanner Hardware.
The following units are connected to the CAN Bus:
− FL Controller as Master
− Algorithm/interface board
− CG Controller
− APS Cartridge Feeder
− Zoom (Lens Group)
The ID of the CAN nodes is set in the Software and
not by way of DIP switches.
The Software protocol is specified in Register 8
Software.
LVDS
Interface (differential line pairs) between the CG
Controller and the image processing board in the
Main PC.
RS232
Serial interface between the Motherboard and the
Main PC.
Ethernet
There are 2 network boards with a transmission
speed of 10 MBit/sec and 100 MBit/sec in the
Main PC.
The 10 MBit board is used for the data transfer
between the algorithm/interface board and the
image processing board (VIPS) in the Main PC.
The 100 MBit board connects the d-lab.3 to an
external network.
4.3.34 2001-01-02 /PN 9009 AGFA d-lab.3