AGFA d-lab.3 Digital Compact Lab

Repair
Scanner
The TFS is not performed on the algorithm board,
but on the PC (see previous section FL Controller)
See Algorithm/interface board and LEDs in
Register 4.1.
Properties:
− SAB 167CR as Microcontroller
− 1Mbyte Flash to store codes and data (externally
programmable by means of a Bootstrap logic)
− 1Mbyte SRAM for data
− Bootstrap logic to program the Microcontroller
from a PC (RS232)
− CAN-interface for the communication with other
components of the SC Hardware
− I²C-EEPROM to store board-specific data, e.g.
board numbers.
− LEDs to show the internal statuses
− Selection of the clocks for the Prescanner.
By means of a selector logic, the clocks of the
film advance or Scanner motor can be sent to the
Prescanner undivided or divided in two. This
allows the Prescanner to synchronise with the
film or carriage movement.
− Ethernet Controller (10 MBit) for fast data
transfer to the Main-PC
AGFA d-lab.3 2001-01-02 /PN 9009 4.3.29