AGFA d-lab.3 Digital Compact Lab

Repair
Scanner
Activation of Motors and Loads
Stepper Motor Data
Name Designation Motor type,
angle
Operating
mode
Rated
voltage
[V]
Starting/
breaking
current
[A]
Running
current
[A]
DS_MO01 Auxiliary shutter 2PH, 1.8° Half step 24 1,7 1,4 0,3
0,9°
FF_MO01 Feeder motor 2PH, 1.8° Full step 24 0,9
FF_MO02 Film transport in 2PH, 1.8° Full step 24 0,9
Feeder
LH_MO01 Filter wheel 2PH, 1,8° Half step 32 – 40 3,4 3,2 0,3
0,9° (24)
LH_MO02 KG filter 2PH, 1.8° Half step 32 – 40 2,0 2,0 1,0
0,9° (24)
LH_MO03 Light shutter 2PH, 1,8° Half step 32 – 40 3,9 3,0 1,0
0,9° (24)
NC_MO01 Film drive 5PH, 0.72° Full step 0,95
SC_MO01 Scanner carriage 5PH, 0.72° Full step 0,75
Stop
current
[A]
Direction of rotation / transport (cw turning) (3)
Name Control, output Direction of rotation
stage (1)
with DIR=High (2)
DS_MO01 FL, LH LHS OPEN-CLOSED frosted glass
FF_MO01 FL, DS — Feeder closes
FF_MO02 FL, DS — Film moving out of the Feeder
LH_MO01 FL, LH LHS R-Neg, R-Dia, G-Neg, G-Dia, ....
LH_MO02 FL, LH LHS Filter is turned out
LH_MO03 CG, LH LHS See separate description
NC_MO01 FL, FD/SD RHS Film transported to the right
SC_MO01 FL, FD/SD RHS Scanner pushed into the light path
(1) FL FL Controller
GG GC Controller
LH LH Output Stage
DS Driver/Sensor-Board
FD/SD FD/SD Output Stage
(2) The direction for DIR=High is defined when looking
on the turning motor shaft.
(3) The direction of rotation / transport refers to a cw
turning motor.
AGFA d-lab.3 2001-01-02 /PN 9009 4.2.5