d-lab.1

More documents

Recommendations

Info

Capacitor Kit d-lab.1 3.5.3 Installation of the new capacitors Both capacitors are the same, so it is not possible to mix them up. The only thing you have to take care is the polarity! If it is wrong, the capacitor will be destroyed! ‣ First install C3 Put some solder on one of the 2 points. Fix the capacitor on that point. Then solder the capacitor on the second point. ‣ Install C126 in the same way. The picture shows the correct polarity. AGFA d-lab.1 CM+9.8072.9003.0/DD+18070312D0/PN04073_00 11
Modification Capacitor Kit d-lab.1 3.5.4 Reinstallation of the LCD driver board The resinstallation has to be done very carefully, otherwise fluctiations of the print quality will come up. Before you install the heat sink on the board, put some heat sink compount on all 4 ICs and on the heat sink. When you fix the screw of the heat sink, be careful. The torque limit is 0.13 Nm only! Again be very careful with the connector of the flat cable. Push the cable into the connector and then lock it. Finally mount all parts in reversed order of dismounting. 12 CM+9.8072.9003.0 AGFA d-lab.1
Page 1 and 2: Service Instructions Digital Minila
Page 3 and 4: Capacitor Kit d-lab.1 Content 1 Lis
Page 5 and 6: Modification Capacitor Kit d-lab.1
Page 13: Modification Capacitor Kit d-lab.1
Page 17 and 18: Attachment Capacitor Kit d-lab.1 33
Page 27 and 28: Attachment Capacitor Kit d-lab.1 4.
Page 37: Attachment Capacitor Kit d-lab.1 46

d-lab.1

Create successful ePaper yourself

Delete template?

Save as template?