zehnder charleston zehnder charleston completto zehnder ...

Connection modes for zehnder charleston completto radiators and special design radiators
zehnder charleston
Connection codes - zehnder charleston completto (additional cost applies)
1/2" L
L 1/2"
1/2" L
1/2" L
1/2" L
V 1/2" R 1/2"
V 1/2" R 1/2"
V 1/2" R 1/2"
V 1/2" R 1/2"
built-in valve on top,
bottom, same-side connection
built-in valve on the bottom,
bottom, same-side connection
built-in valve on top,
bottom, middle connection
built-in valve on top,
bottom, opposite-side connection
V = flow, R = return, L = air vent, E = water drain, B = blind plug, O = buffle (standard), • = buffle (100% watertight)
Special designs
Description
Additional special connections
Fully welded construction
high-pressure design max. 18 bar (not possible for Completto design)
Angled or curved design
Radiator design over 3000 mm high
For an additional cost
(calculated upon request).
Welded-on lifting eyes
Extended length radiator, assembled from segments using nipples
Zinc-plated construction
(see explanation on page 416)
Zinc plating with subsequent finishing using enamel of standard colour (RAL 9016)
Insert tube
In the event a Zehnder Charleston radiator has same-side connections
and the number of its sections exceeds the number indicated
below, the radiator may be designed with a factory-installed insert tube
that will guarantee achieving the heat capacity ratings shown in
the catalog (additional cost applies)
2-column model
3-column model
4-column model
5-column model
6-column model
from 87 sections = installation length 4002 mm
from 85 sections = installation length 3910 mm
from 81 sections = installation length 3726 mm
from 71 sections = installation length 3266 mm
from 55 sections = installation length 2530 mm
Einsatzrohr
Insert tube
1
/3 2
/3
Supply Vorlauf
Rücklauf
Return
9