Lionel NW-2 diesel locomotive Owner's Manual
Lionel NW-2 diesel locomotive Owner's Manual
Lionel NW-2 diesel locomotive Owner's Manual
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Maintaining and servicing your <strong>NW</strong>-2 <strong>locomotive</strong><br />
Replacing your <strong>NW</strong>-2’s Lamp Harness<br />
Your <strong>NW</strong>-2 <strong>locomotive</strong> is illuminated by<br />
two 14-volt long life lamps. One<br />
illuminates the rear light and the other<br />
illuminates the front light. During the<br />
course of normal operation, they may<br />
require replacement.<br />
Start by separating the plastic body shell;<br />
see the previous section on motor lubrication<br />
for detailed shell-removal information.<br />
Carefully lift the shell away from the frame.<br />
Take care with the various wiring assemblies<br />
connected to the shell.<br />
Locate the Wire Harness Assembly<br />
containing the expired bulb or bulbs. Note:<br />
If one bulb is burned out the whole Light<br />
Harness needs to be replaced. It’s held in<br />
position by a retaining clip inside engine<br />
cab and a light bracket at the front of the<br />
engine frame. Carefully remove the Lamp<br />
Harness assembly and discard. Replace with<br />
new Light Harness <strong>Lionel</strong> part no. 6-10-<br />
8959-326, available from your local<br />
authorized <strong>Lionel</strong> Service Center or <strong>Lionel</strong><br />
Service (See below illustration for further<br />
instruction).<br />
Light Harness<br />
<strong>Lionel</strong> Part No.<br />
6-10-8959-326<br />
Remove whole Light Harness to replace the expired bulb or bulbs. Then Re-insert new first light<br />
(shorter wired light) of the Light Harness into the lamp bracket located at the front of the engine<br />
frame. Then Re-insert new second light (longer wired light) of the Light Harness into Light Clip<br />
inside roof of the engine cab as shown. Plug the 5 pin Light Harness Plug into the 5 pin socket as<br />
shown.<br />
Note!<br />
Press Aux2 to make sure headlamp was not accidently turned off,<br />
before replacing bulb<br />
15