Lionel Little Lines The Polar Express Set Owner's Manual

More documents

Recommendations

Info

Battery installation (Requires Adult Installation) • Requires 6 “AAA” ALKALINE (RL03) batteries (not included) and a small Phillips screwdriver (not included). • Three batteries are used for the Controller and three are used for the Engine. • Do not mix new and old batteries together. • Lionel recommends using only Alkaline batteries for best performance . • Never mix battery brand or types. • Remove batteries if the toy is not to be used for an extended period. Battery installation - Engine (Requires Adult Installation) To open battery door loosen the two screws in the back of the engine cab with a Phillips screw driver. Note: the screws will remain attached to the door after loosened. Open the battery door as shown and insert three “AAA” (LR03) ALKALINE batteries. Important! The Positive (+) and Negative (-) signs beneath the holes for the batteries indicate the end of the battery you should see when in place. You should see the Positive end of the top battery and the Negative end of the lower two. After inserting the batteries close the door and tighten the screws. Be sure the screws are tightened snuggly to insure the good contact with the battery terminals. (Take care not to over tighten). Battery installation - Controller (Requires Adult Installation) To open battery door loosen the screw on the bottom of the controller with a Phillips screw driver. Lift battery door by tab near screw. Note: the screw will remain attached to the battery door after loosened. Insert three “AAA” (LRO3) ALKALINE batteries positioned as shown in the back of the compartment. Replace the battery cover and tighten the screw to secure (Take care not to over tighten). Note! The switch at the bottom of the battery box allow the parent to turn off the sound features on this product. It is automatically preset to the Sounds On position. To turn the controller sounds off slide the switch to the alternate position). Sounds can be re-activated at any time by moving this switch back to the original Factory preset position. Important! REMOVE ALL BATTERIES WHEN THE TRAIN WILL NOT BE USED FOR AN EXTENDED PERIOD OF TIME. 4 Lionel Little Lines PE.indd 4 12/29/09 1:54 PM
Assembling track sections Align the ends of the track and press firmly until they snap together. Disassembling track sections Hold track in both hands bending the joint downwards until the track snaps apart. One-time assembly of upper and lower ramp track sections Note! THIS IS A ONE TIME ASSEMBLY. DO NOT ATTEMPT TO SEPARATE THESE PARTS IN THE FUTURE. Align the Upper Ramp and Lower Ramp section together as shown. Press together firmly until they snap together. Ramp tracks are used to transition your train from the ground to a second level support by a Stone Arch. 5 Lionel Little Lines PE.indd 5 12/29/09 1:54 PM
Page 1 and 2: 71-1156-250 7/09 Rev 1 Lionel Littl
Page 3: FCC Statement This devise complies
Page 7 and 8: Track layout Curve Upper ramp track
Page 9 and 10: Installing the batter in your contr
Page 11 and 12: Troubleshooting: Train will not run

Lionel Little Lines The Polar Express Set Owner's Manual

Create successful ePaper yourself

Delete template?

Save as template?