Lionel Little Lines The Polar Express Set Owner's Manual

Battery installation (Requires Adult Installation)
• Requires 6 “AAA” ALKALINE (RL03) batteries (not included) and a small Phillips screwdriver (not
included).
• Three batteries are used for the Controller and three are used for the Engine.
• Do not mix new and old batteries together.
• Lionel recommends using only Alkaline batteries for best performance .
• Never mix battery brand or types.
• Remove batteries if the toy is not to be used for an extended period.
Battery installation - Engine (Requires Adult Installation)
To open battery door loosen the two screws in the
back of the engine cab with a Phillips screw driver.
Note: the screws will remain attached to the door after
loosened. Open the battery door as shown and insert
three “AAA” (LR03) ALKALINE batteries.
Important!
The Positive (+) and Negative (-)
signs beneath the holes for the batteries
indicate the end of the battery you
should see when in place. You should
see the Positive end of the top battery
and the Negative end of the lower two.
After inserting the batteries close the door and tighten the screws. Be sure the screws are tightened
snuggly to insure the good contact with the battery terminals. (Take care not to over tighten).
Battery installation - Controller (Requires Adult Installation)
To open battery door loosen the screw on the bottom of the controller with a Phillips screw driver.
Lift battery door by tab near screw. Note: the screw will remain attached to the battery door
after loosened. Insert three “AAA” (LRO3) ALKALINE batteries positioned as shown in the back of
the compartment. Replace the battery cover and tighten the screw to secure (Take care not to over
tighten).
Note!
The switch at the bottom of the battery box allow the parent to turn off the sound features
on this product. It is automatically preset to the Sounds On position. To turn the controller
sounds off slide the switch to the alternate position). Sounds can be re-activated at any
time by moving this switch back to the original Factory preset position.
Important!
REMOVE ALL BATTERIES WHEN THE TRAIN WILL NOT BE USED FOR AN
EXTENDED PERIOD OF TIME.
4
Lionel Little Lines PE.indd 4
12/29/09 1:54 PM