Operating Oil Drum Loader - Lionel
Operating Oil Drum Loader - Lionel
Operating Oil Drum Loader - Lionel
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Place the platform assembly adjacent to the track as close to the train as possible without causing interference. Note: for “0”<br />
gauge layouts it may be necessary to raise the oil barrel loader approximately 1/2 “. Set the forklift loader on the platform<br />
over the outermost pin on the drive arm so that the hole on the front underside of the forklift loader engages with the pin.<br />
(See Figure 8). Figure 9 shows the position that the forklift loader should be in when the drive arm is at the edge of the platform<br />
farthest away from the barrels.<br />
FIGURE 8<br />
FORKLIFT LOADER PLACEMENT<br />
FIGURE 9<br />
Gondola<br />
OIL DRUM LOADER OPERATION<br />
Load oil drums into chute next to house. Place the forklift driver onto the forklift loader. Position the empty gondola car in<br />
front of the loading platform and sequence reversing unit in locomotive to neutral position. Adjust track voltage to approximately<br />
8 volts, usually at the lower end of most transformer voltage ranges. WARNING: Doing this for an extended period of<br />
time could damage a locomotive equipped with a smoke unit. Turn power switch on and watch the drums load into the gondola<br />
car. Turn switch off after the last barrel has been loaded. The train is now ready to deliver oil drums to their destination.<br />
MAINTENANCE PROCEDURE<br />
This unit should be maintenance free under normal operating conditions.<br />
Frequent or continuous operation may call for lubrication should the unit<br />
begin slowing down or operating erratically. Turn the unit upside down and<br />
apply one drop of machine oil to each of the 4 pivot points as shown.<br />
4 3<br />
2<br />
FIGURE 10<br />
1<br />
SERVICE<br />
This product is proudly offered by <strong>Lionel</strong> Trains, Inc. and it carries a warranty to support its continued reliable operation. You may choose to have<br />
the <strong>Lionel</strong> Service Department service your item even after its warranty expires.If so, a reasonable service fee will be charged. In either event,<br />
please follow the directions below.<br />
If service is required within the warranty period, bring the item to the nearest authorized <strong>Lionel</strong> Trains-Service Center along with the warranty<br />
card. If you prefer to send it back to the factory, you must first write to Customer Service, P.O. Box 748 New Baltimore, MI 48047-0748 stating<br />
what the item is, when it was purchased and what seems to be the problem. You will be sent a return authorization and a label to assure your<br />
merchandise will be properly handled upon receipt.<br />
CAUTION: Make sure the item is packed so as to prevent damage to the merchandise. The shipment must be prepaid and we recommend that it<br />
be insured.<br />
Please make sure you have followed the instructions carefully before returning any merchandise for service. This warranty gives you specific<br />
legal rights and you may have others that vary from state to state.<br />
4