TO 35-1-3 - Robins Air Force Base

More documents

Recommendations

Info

TO 35-1-3 Table A-1. Equipment and Consumable Materials List - Continued Nomenclature/Description Specification Stock Number Unit of Issue Solvent, Dry Cleaning MIL-PRF-680, Type II or CID A-A-59601 6850-00-110-4498 6850-00-637-6135 6850-00-274-5421 6850-00-285-8011 PT GL CN DR MIL-PRF-680 Type III or CID A-A-59601 6850-01-331-3349 6850-01-331-3350 CN DR MIL-PRF-32295, Type II 6850-01-606-8356 6850-01-606-8357 6850-01-606-3293 6850-01-606-8358 GL 5 GL 15 GL 55 GL (As an alternate method) use a (5PClocal purchase) 3m Rubber wheel, part number 07498 for removing vinyl reflectors and vinyl stencils from equipment Spray Kit, Preval with Compressed Gas Canister and Glass Bottle Spray Kit, Preval Spray Compressed Gas Canister Tape Pressure Sensitive 267-1 8020-01-501-3127 EA 268-1 8020-01-496-2473 EA SAE-AMS-T-23397, Type II 1/2 -inch 7510-00-476-8841 RO 1-inch 7510-00-473-9855 RO 2-inch 7510-00-473-9513 RO NOTE • SEMPENs are approved for touch-up on polyurethane surfaces. Respirator use is not normally required; however, organizations shall gain approval from the local bioenvironmental engineer prior to using the SEMPEN without a paint respirator. • Preval Spray System/Power Pack Spray Systems are atomizing paint touchup spray systems. PPE shall be worn when spraying polyurethane and epoxy primer. • Single component aerosols are not authorized for use on any SE. A-8 Change 9
Page 1 and 2:
TO 35-1-3 TECHNICAL MANUAL CORROSIO
Page 3 and 4:
TO 35-1-3 TABLE OF CONTENTS Chapter
Page 5 and 6:
TO 35-1-3 TABLE OF CONTENTS - Conti
Page 7 and 8:
TO 35-1-3 LIST OF ILLUSTRATIONS Num
Page 9 and 10:
TO 35-1-3 FOREWORD 1. PURPOSE. The
Page 11 and 12:
TO 35-1-3 SAFETY SUMMARY 1. GENERAL
Page 13 and 14:
CHAPTER 1 CORROSION THEORY, IDENTIF
Page 15 and 16:
TO 35-1-3 Table 1-1. Galvanic Serie
Page 17 and 18:
TO 35-1-3 sion. Improper dilution o
Page 19 and 20:
TO 35-1-3 1.6.7.3 When dry, some mi
Page 21 and 22:
TO 35-1-3 Figure 1-7. Example of Pi
Page 23 and 24:
TO 35-1-3 Figure 1-11. Illustration
Page 25 and 26:
TO 35-1-3 1.8 METALS AFFECTED BY CO
Page 27 and 28:
TO 35-1-3 CHAPTER 2 CLEANING 2.1 GE
Page 29 and 30:
TO 35-1-3 E Table 2-1. Wash Interva
Page 31 and 32:
TO 35-1-3 Table 2-1. Wash Interval
Page 34 and 35:
TO 35-1-3 2.1.5.3 Immersion in clea
Page 36 and 37:
TO 35-1-3 2.1.6.2.10 MIL-PRF-87937,
Page 38 and 39:
TO 35-1-3 Table 2-2. Authorized Cle
Page 40 and 41:
TO 35-1-3 2.1.7.2 Cleaning Compound
Page 42 and 43:
TO 35-1-3 removal and surface treat
Page 44 and 45:
TO 35-1-3 2.2.6.1 Authorized HPW Eq
Page 47 and 48:
TO 35-1-3 CHAPTER 3 PAINTING, SEALI
Page 49 and 50:
TO 35-1-3 3.3.2.3.1 Unless otherwis
Page 51 and 52:
TO 35-1-3 Table 3-1. Authorized Coa
Page 53 and 54:
TO 35-1-3 3.5.2.3 Air Force will ac
Page 55 and 56:
TO 35-1-3 with AMS 3367, Class A or
Page 57 and 58:
TO 35-1-3 3.11 MAINTENANCE STAND RA
Page 59 and 60:
TO 35-1-3 b. Type III An ultra thin
Page 61 and 62:
TO 35-1-3 Table 3-2. Pretreatment I
Page 63 and 64:
TO 35-1-3 b. Azko Nobel 10P3-2 Akzo
Page 65 and 66:
TO 35-1-3 removed prior to the fina
Page 67 and 68:
TO 35-1-3 3.22.1 SE Undercoating Co
Page 69:
TO 35-1-3 3.26.7 Wire Harness and C
Page 72 and 73:
TO 35-1-3 4.2.3.4 Other optional in
Page 74 and 75:
TO 35-1-3 Figure 4-3. Sample Mobili
Page 76 and 77:
TO 35-1-3 Legend for Figure 4-4. In
Page 78 and 79:
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
TO 35-1-3 Legend for Figure 4-10. I
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
TO 35-1-3 Pages 4-46 and 4-47 were
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149: TO 35-1-3 Legend for Figure 4-41. I
Page 174 and 175: TO 35-1-3 Legend for Figure 4-53 -
Page 178 and 179: TO 35-1-3 Figure 4-54. New Generati
Page 180 and 181: TO 35-1-3 Figure 5-1. Angle Iron Se
Page 182 and 183: TO 35-1-3 87937, Type I), which con
Page 184 and 185: TO 35-1-3 • Gas Tungsten-Arc (TIG
Page 187 and 188: TO 35-1-3 CHAPTER 7 SOUTHWEST ASIA
Page 189: TO 35-1-3 7.2.2.1.6 Felt-Soundproof
Page 192 and 193: TO 35-1-3 Table A-1. Equipment and
Page 194 and 195: TO 35-1-3 Nomenclature/Description
Page 196 and 197: TO 35-1-3 Table A-1. Equipment and
show all

TO 35-1-3 - Robins Air Force Base

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?