MicroVertex G4 A Quick Users Guide 2007 - R&M Materials ...

R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
: (800) 955-9967
www.rmhoist.com
SELECTION FILTER BUTTON
The selection filter button can be used so the drawing cursor snaps to a specific element type
in the drawing. Conversely, an element type (or types) in the selection filter can be turned off
so the drawing cursor will not snap to a specific element type in the drawing.
Element types are lines, text, dimensions, hatches, projections, macros, or groups.
All the element types are turned on when the drawing is initially opened. A check mark next
to the element type listed in the menu indicates that the element is turned on.
Turning off an element
1. Click on the down arrow next to Selection filter button to pull down the selection filter
menu.
2. Click once on the element that you want to uncheck.
Turning on an element
1. Click on the down arrow next to Selection filter button to pull down the selection filter
menu.
2. Click once on the element to activate it.
1
2
ELEMENT SELECTION
Window selection
• Move the cursor to make a rectangle using two points around the elements you want
to copy. (Selected elements turn purple.)
Cursor selection
• Move the cursor over the element you want to select, and then select the element by
doing a single left mouse click. To select more than one element with the cursor, hold
down the Ctrl button on keyboard while clicking with the left mouse button. (Selected
elements turn purple.)
R&M Materials Handling Inc. reserves the right to alter or amend the above information without notice Page 9 of 31 7/10/2007