MicroVertex G4 A Quick Users Guide 2007 - R&M Materials ...

More documents

Recommendations

Info

R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 : (800) 955-9967 www.rmhoist.com 3. Select the printer name from the Printer box. 4. Modify the printer properties as needed by clicking the Properties button. 5. Select Fit to sheet in the Scale box. 6. Center the drawing on the sheet by clicking the middle button. 7. Rotate the drawing if needed. 8. Click OK to print. 6 3 4 5 7 8 R&M Materials Handling Inc. reserves the right to alter or amend the above information without notice Page 8 of 31 7/10/2007
R&M Materials Handling, Inc. 4501 Gateway Boulevard Springfield, Ohio 45502 : (800) 955-9967 www.rmhoist.com SELECTION FILTER BUTTON The selection filter button can be used so the drawing cursor snaps to a specific element type in the drawing. Conversely, an element type (or types) in the selection filter can be turned off so the drawing cursor will not snap to a specific element type in the drawing. Element types are lines, text, dimensions, hatches, projections, macros, or groups. All the element types are turned on when the drawing is initially opened. A check mark next to the element type listed in the menu indicates that the element is turned on. Turning off an element 1. Click on the down arrow next to Selection filter button to pull down the selection filter menu. 2. Click once on the element that you want to uncheck. Turning on an element 1. Click on the down arrow next to Selection filter button to pull down the selection filter menu. 2. Click once on the element to activate it. 1 2 ELEMENT SELECTION Window selection • Move the cursor to make a rectangle using two points around the elements you want to copy. (Selected elements turn purple.) Cursor selection • Move the cursor over the element you want to select, and then select the element by doing a single left mouse click. To select more than one element with the cursor, hold down the Ctrl button on keyboard while clicking with the left mouse button. (Selected elements turn purple.) R&M Materials Handling Inc. reserves the right to alter or amend the above information without notice Page 9 of 31 7/10/2007
Page 1 and 2: R&M Materials Handling, Inc. 4501 G
Page 3 and 4: INTRODUCTION R&M Materials Handling
Page 7: R&M Materials Handling, Inc. 4501 G
Page 15 and 16: DIMENSIONING R&M Materials Handling
Page 31: R&M Materials Handling, Inc. 4501 G

MicroVertex G4 A Quick Users Guide 2007 - R&M Materials ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?