MicroVertex G4 A Quick Users Guide 2007 - R&M Materials ...

R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
: (800) 955-9967
www.rmhoist.com
ADDING, EDITING, DELETING A LINE
Adding lines
1. Click on the down arrow next to Line button to pull down the line type command menu.
2. Select a line type from the menu.
3. Move the cursor to the point where you want to start the line.
4. Do a left mouse click and move the cursor to point where you want to end the line.
Press letter “e” on the keyboard for a vertical line and letter “w” for a horizontal line.
5. Left click again and move your cursor to the finishing point.
6. To finish a line, click the center button on the mouse or push “Esc” or “v” on the
keyboard.
1
R&M Materials Handling Inc. reserves the right to alter or amend the above information without notice Page 17 of 31 7/10/2007