SERVICE MANUAL - O. Rensch OHG
SERVICE MANUAL - O. Rensch OHG
SERVICE MANUAL - O. Rensch OHG
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
2DC<br />
Maintenance<br />
item No.<br />
Description<br />
U073 Checking scanner operation<br />
Description<br />
Simulates the scanner operation under arbitrary conditions.<br />
Purpose<br />
To check scanner operation.<br />
Method<br />
1. Press the start key.<br />
2. Select the item to be changed by lighting a copy exposure indicator using the copy exposure adjustment<br />
keys.<br />
3. Change the setting using the zoom +/– keys.<br />
Copy exposure indicator Operating conditions Setting range<br />
Exp. 1 Magnification 50 to 200%<br />
Exp. 2 Paper size See below.<br />
Exp. 3 On and off of the exposure lamp on or off<br />
U074<br />
Paper size for each setting<br />
Setting Paper size Setting Paper size<br />
9 B5 47 Folio<br />
40 A4R 55 8 1 /2" × 14"<br />
41 B5R 56 8 1 /2" × 11"R<br />
42 A5R 58 5 1 /2" × 8 1 /2"R<br />
4. Press the start key. Scanning starts under the selected conditions.<br />
5. To stop operation, press the stop/clear key.<br />
Completion<br />
Press the stop/clear key when scanning stops. The indication for selecting a maintenance item No. appears.<br />
Adjusting the DP input light luminosity<br />
Description<br />
Adjusts the luminosity of the exposure lamp for scanning originals from the DP.<br />
Purpose<br />
Used if the exposure amount differs significantly between when scanning an original on the contact glass and<br />
when scanning an original from the DP.<br />
Method<br />
Press the start key.<br />
Setting<br />
1. Change the setting using the zoom +/– keys.<br />
Description Setting range Initial setting<br />
DP input light luminosity 0 to 8 1<br />
Increasing the setting makes the luminosity higher, and decreasing it makes the luminosity lower.<br />
2. Press the start key. The value is set.<br />
Test copy mode<br />
While this maintenance item is being performed, copying from an original can be made in test copy mode.<br />
Completion<br />
Press the stop/clear key. The indication for selecting a maintenance item No. appears.<br />
1-4-10