SERVICE MANUAL - O. Rensch OHG

2DC
Connect the power cord.
1. Connect the power cord.
Figure 1-3-22
Power cord
Initializing the copier.
1. Turn the main switch to the copier ON ( | ).
Power switch
Figure 1-3-23
First “900” will appear in the copy quantity/
magnification display on the copier's operation
panel. The copier will then begin operation and a
countdown of the time until the copier will be
ready will be shown (900 seconds = 15 minutes).
As the copier is carrying out the necessary toner
supply operation, you will need to wait until that
operation is completed.
Once the copier is in a copy-ready state, “1” will
appear in the copy quantity/magnification display
and the Start indicator will light.
Figure 1-3-24
1-3-11