SERVICE MANUAL - O. Rensch OHG

2DC
3. Remove two screws and then remove two grounding plates.
4. Remove the one stopper ring and then detach the scanner shaft.
* Detach the shaft taking care to tilt it as little as possible.
Screw
Stopper ring
Screw
Grounding plates
Scanner shaft
Figure 1-6-37 Detaching the scanner shaft
5. Remove the flexible flat cable from the ISU
board’s connector.
6. Remove the scanner belt from the belt hook
of scanner unit.
7. Remove the ISU unit from the scanner shaft.
* Remove the ISU unit taking care not to lose
the M4 nut located in the ISU unit.
M4 nut
Scanner unit
Belt hook
Scanner belt
ISU board
Scanner shaft
Flexible flat cable
ISU unit
Figure 1-6-38 Removing the ISU unit
1-6-33