SERVICE MANUAL - O. Rensch OHG

2DC
1-6-11 Removing the laser scanner unit and the eraser lamp
1. Remove the scanner unit (See page 1-6-27).
2. Remove each two screws and then remove
two grounding plates.
3. Remove each two screws and then remove
the right and left scanner stays.
Screws
Left scanner stay
Screws
Grounding plates
Right scanner stay
Screws
Figure 1-6-31 Removing the right and left stays
4. Remove four connectors.
5. Remove six screws and then remove the LSU
shield.
* When refitting the LSU shield, tighten a
screw in order of 4 from 1.
Screws
4
Screw
LSU shield
3
2
1
Screws
Connectors
Screw
Figure 1-6-32 Removing the LSU shield
1-6-29