SERVICE MANUAL - O. Rensch OHG
SERVICE MANUAL - O. Rensch OHG
SERVICE MANUAL - O. Rensch OHG
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
2DC<br />
(2) Removing the heater lamp<br />
WARNING<br />
• The heater lamp is extremely hot immediately after the copier was running.<br />
• Allow substantial period of time until it cools down. Also, the heater lamp is fragile: Handle it with great care.<br />
CAUTION<br />
• The heater lamps are fragile. Use extreme care when handling not to drop or break.<br />
• Do not directly touch on the heater lamp. Finger prints on the heater lamp’s outer surface can prevent proper fusing of<br />
toner on paper. When holding<br />
• When refitting the heater lamp, direct the short distance side from the projection in the middle of the lamp facing the<br />
machine’s left side.<br />
1. Remove and split the fuser unit (See page 1-6-18).<br />
2. Remove all (four) separation claws (See previous page).<br />
3. Remove one screw, release the tension of the lamp A holder.<br />
4. Remove the heater lamp form the lamp B holder.<br />
5. Remove the heater lamp from the heat roller.<br />
Lamp A holder<br />
Machine<br />
right side<br />
Long<br />
Screw<br />
Machine<br />
left side<br />
Heater lamp<br />
Projection<br />
Short<br />
Lamp B holder<br />
Figure 1-6-23 Removing the heater lamp<br />
1-6-21
Change language