Lefty PBR 130 Owner's Manual Supplement - Eighty-Aid

More documents

Recommendations

Info

xc3 stem-steerer The following procedure should be completed by a professional bike mechanic. Installation 1. Loosen both clamp bolts . 3. Position the <strong>Lefty</strong> clamps onto the headtube assembly as shown. 4. Insert Cannondale tool KT020/ through the bottom clamp, into the head tube, and out the upper clamp. 5. Make sure the plastic ring is on the stem. Insert the bottom of the stem-steerer onto the top of the tool. 6. Remove the cap from the top of the steerer. Use a rubber mallet to drive the stem-steerer into the head tube until it stops. Return the cap. 7. Clean and apply grease to the steerer bolt threads and install into the bottom of the stem-steerer. The bolt is a structural part that threads into the bottom of the stemsteerer. Align handlebar and tighten the bolt to 9 N•m. 8.. Tighten the upper and lower clamp bolts to 9 N•m. Removal 1 Loosen upper and lower clamp bolts. 2. Remove steerer bolt. Use a 5mm Allen key; turn counter-clockwise. 3. Insert the small end of KT020/ into the bottom of the stem-steerer and drive the stem-steerer up out of the head tube. 18
122168.PDF XC3 Stem-Steerer kits in various sizes are available through your Cannondale Dealer. NOTES: 1. When removing or installing steerer bolt, insert 5mm Allen key completely to prevent stripping the bolt. 2. The drain hole enables accumulated moisture to drain out. Use a toothpick to keep it clear. WARNING The steerer bolt is a structural part and must be installed. 19
Page 1 and 2: READ THIS SUPPLEMENT AND YOUR CANNO
Page 3 and 4: 122168.PDF Fork Damage WARNING STOP
Page 5 and 6: 122168.PDF
Page 7 and 8: 122168.PDF Rebound The red rebound
Page 9 and 10: 122168.PDF Riding in Wet, Humid, or
Page 11 and 12: 122168.PDF Wheel Installation 1. In
Page 13 and 14: 122168.PDF NO. ORDER NO. KIT DESCRI
Page 15 and 16: 122168.PDF 4 NEEDLE BEARING CAGES N
Page 17: 17 122168.PDF

Lefty PBR 130 Owner's Manual Supplement - Eighty-Aid

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?