Q CELLS - Installation manual G3 solar modules - Hanwha Q CELLS

More documents

Recommendations

Info

2 PLANNING 150 2.1 Technical specifications 1670 980 6 x Grounding points ø 4.5 Product label Frame 1210 Cable with connectors 1000 Junction box 4 x Fastening points, long slot 8 x 16 8 x Drainage holes Fig. 1: External dimensions (in mm) and components for Q.PRO-G3, Q.PEAK-G3, Q.PEAK BLK-G3 150 1348 788 6 x Grounding points ø 4.5 Product label Frame 1210 Cable with connectors 1000 Junction box 4 x Fastening points, long slot 8 x 16 8 x Drainage holes Fig. 2: External dimensions (in mm) and components for Q.PEAK S-G3 6 INSTALLATION AND OPERATION MANUAL SOLAR MODULES GENERATION 3 (G3) – HANWHA Q CELLS GMBH – EN
2 PLANNING 2.2 Requirements Installation Site Please note the following guidelines that apply to the installation site: • The modules have been tested according to IEC 61215 for operation in a temperate climate. • Solar modules are not explosion-proof. ÄÄDo not operate solar modules near highly flammable gas and vapors (e.g., gas tanks,gas stations). ÄÄDo not install modules in enclosed space. ÄÄDo not install modules in locations where they may be submerged in water for lengthy periods. Prevention of Shadowing Effects Optimalsolar irradiation leads to maximum energy output: ÄÄFor this reason, install the modules so that they face the sun. ÄÄAvoid shadowing (due to objects such as buildings, chimneys, or trees). ÄÄAvoid partial shading (for example through overhead lines, dirt, snow). Limitations The solar modules are designed for the following applications: • Operating temperatures from –40 °C to +85 °C (–40 °F to +185 °F). • Wind and snow loads up to max. 5,400 Pa (as tested according to IEC 61215). • Installation using a mounting frame for solar modules. • Clamps are not in contact with the front glass. • Clamps do not deform the frame. • Clamps that satisfy the structural requirements of the installation site. • Long-term stable clamps that securely affix the module to the mounting frame. Module Orientation Requirements • Vertical or horizontal installation is permitted. ÄÄEnsure that rain and melting snow can run off freely. No water accumulation. ÄÄEnsure that the drainage holes in the frame are not covered. No sealing. ÄÄMaintain the permissible angle of inclination. • Minimum angle of inclination: 3° • Maximum angle of inclination: 80° • Follow the directions for installation angles < 5° (“Grounding”, p. 19) Mounting Frame Requirements Requirements for the mounting frame: • Conforms to the necessary structural requirements. • Compliant with local snow and wind loads. • Properly fastened to the ground, the roof, or the façade. • Forces acting on the module are relayed to the mounting substructure. • Ensures sufficient rear ventilation of the module. • Guarantees long-term stability. • Has electrochemical series that prevent corrosion among different metals. • Allows for stress-free expansion and contraction due to temperature fluctuations. ÄÄEnsure that no mechanical stresses (e.g., caused by vibrations, twisting, or expansion) are generated on the module. ÄÄEnsure that the clamps and the mounting frame are compatible. Clamp System Requirements Use customary clamps that satisfy the following requirements: • Clamp width: ≥ 40 mm. • Clamp height compliant with a 35 mm frame height. • Clamp depth: 7–12 mm. Inverter Inverter • A module with 1,210 mm-long cable can be wired as a "2nd next neighbor". "2nd next neighbor" - Wiring without a return cable. Standard wiring with a return cable 1 2 INSTALLATION AND OPERATION MANUAL SOLAR MODULES GENERATION 3 (G3) – HANWHA Q CELLS GMBH – EN 7
Page 1 and 2: INSTALLATION AND OPERATION MANUAL C
Page 3 and 4: 1 INTRODUCTION With solar modules f
Page 5: 2 PLANNING 2.1 Technical specificat
Page 9 and 10: 2 PLANNING 2.3 Mounting options Spe
Page 11 and 12: 3 INSTALLATION 3.1 Safety and trans
Page 13 and 14: 3 INSTALLATION 3.2 Preparation of i
Page 15 and 16: 4 ELECTRICAL CONNECTION 4.1 Safety
Page 17 and 18: 4 ELECTRICAL CONNECTION 4.3 Connect
Page 19 and 20: 5 GROUNDING Protective Grounding Ä
Page 21: CONTACT HANWHA Q CELLS GMBH OT Thal

Q CELLS - Installation manual G3 solar modules - Hanwha Q CELLS

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?