Palco 3/5 - Prolight

More documents

Recommendations

Info

SGM Elettronica - Light Technology GB Now loosen the 8 hex screws that fix the lens-holder panel to the LED matrix, aligned below, using a 2.5mm. key. To install the new set of lenses, proceed as follows. Carefully avoid touching the single lenses that make up the set. Should this happen, clean it/them carefully with a soft dry cloth. User's manual 1.01 - 42 - Palco 3 - Palco 5
GB SGM Elettronica - Light Technology Installing the new front lens panel 3 4 1 2 4 3 1 Carefully position the new set of lenses, paying particular attention to the alignment of the LEDs in relation to the lenses. ATTENTION !! before positioning the new set of lenses, carefully clean the LEDs with a soft dry cloth. CAREFULLY AVOID TOUCHING THE LEDs – should this occur, clean them with a dry cloth, under no circumstances using solvents, products for removing grease, or abrasive objects. Once the new set of lenses is positioned, fix it to the matrix with the appropriate screws, without tightening them individually, but following an orderly sequence, progressively tightening them in one after another. 2 Replace the front glass, after having cleaned it with a soft dry cloth. 3 Close the 2 (top and bottom) shells of the head, ensuring that the front glass is evenly closed between them. 4 Fix the two shells with the appropriate rear screws. Palco 3 - Palco 5 - 43 - User's manual 1.01
Page 1 and 2: Palco 3/5 Gradav Hire and Sales Ltd
Page 3 and 4: GB SGM Elettronica - Light Technolo
Page 41: GB SGM Elettronica - Light Technolo

Palco 3/5 - Prolight

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?