You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
General Description<br />
1.00 General Description of Major Parts<br />
1.10 <strong>Manual</strong> Control Section<br />
☞<br />
Diagram 1A<br />
This section is used to control the level of individual desk channels. There are 2<br />
faders (Preset 1 and Preset 2) and a Flash button with an inbuilt level indicator per<br />
channel. There is also a writing strip below the Flash buttons.<br />
▲ 1A <strong>Manual</strong> control section<br />
▲ 1B Assign master section<br />
▲ 1C Master section<br />
▲ 1D Menu control section<br />
1.20 Assign Master Section<br />
☞<br />
Diagram 1B<br />
This section is used to control the playback of Memories, Chases and crossfade<br />
Stacks. There are either 12 or 24 Assign Masters (depending on the desk type) and<br />
a corresponding number of Flash buttons. The LCDs located above the Assign<br />
Master faders display labels for the items being controlled.<br />
1.30 Master Section<br />
Diagram 1C<br />
☞<br />
This section includes the Grand Master fader and DBO button, Flash Master fader<br />
and selector switch, Preset Master faders, and a Chase rate control. There is also a<br />
Hold / SMaster fader and switch.<br />
1.40 Menu Control Section<br />
☞<br />
Diagram 1D<br />
The <strong>Event</strong> menu system is used to enter and modify settings for Memories, Chases,<br />
Stacks, Pages and Files while recording and during playback. It is also used to<br />
configure the various setup options.<br />
1.50 Back Panel<br />
Diagram 1E<br />
☞<br />
All power and control connections are made on the rear of the console. This is also<br />
where option panels are fitted. Possible options include:<br />
* 60 way analogue output option<br />
* 30 way analogue output extender option<br />
* MCard option<br />
* MCard/VDU (Mono, CGA, EGA)<br />
* MCard/VDU (VGA)<br />
* Floppy disk drive<br />
▲ 1E Back panel showing M<br />
card option fitted<br />
NOTE:<br />
The keyboard and RS 232 Connections on the rear of the <strong>Event</strong> Plus are for factory<br />
use only.<br />
10 <strong>Event</strong> <strong>V3</strong> <strong>Manual</strong>