Development Consent - Department of Planning
Development Consent - Department of Planning
Development Consent - Department of Planning
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
35 40 50<br />
25 – Fenwick<br />
28A & B – Garland<br />
33 -Thelander/O'Neill<br />
39 – Northcote<br />
40 – Muller<br />
35 39 50<br />
254A – Algie<br />
5 – Strachan<br />
6 - Merrick<br />
7 - Maizey<br />
37 - Lawry<br />
35 38 50<br />
48 - Ponder<br />
1 - Brosi<br />
17 - Carter<br />
18 - Denney<br />
38 - Williams<br />
49 - Oliver<br />
63 - Abrocuff<br />
75 - Barnes<br />
35 37 50<br />
91 - Bailey<br />
27 - Birralee<br />
43 - Carmody<br />
137 - Woodruff<br />
163 - Rodger/Williams<br />
35 36 50<br />
246 - Bailey<br />
13B - Skinner<br />
178 - Smith<br />
188 - Fuller<br />
262A, B & C - Moses<br />
35 35 50 All other residential or sensitive<br />
receptors, excluding the receptors<br />
listed in condition 1 above<br />
Table 9: Noise impact assessment criteria dB(A))<br />
Notes:<br />
a) Noise from the development is to be measured at the most affected point or<br />
within the residential boundary, or at the most affected point within 30 metres<br />
<strong>of</strong> a dwelling (rural situations) where the dwelling is more than 30 metres<br />
from the boundary, to determine compliance with the L Aeq(15 minute) noise limits<br />
in the above table. Where it can be demonstrated that direct measurement<br />
<strong>of</strong> noise from the development is impractical, the DEC may accept alternative<br />
means <strong>of</strong> determining compliance (see Chapter 11 <strong>of</strong> the NSW Industrial<br />
Noise Policy). The modification factors in Section 4 <strong>of</strong> the NSW Industrial<br />
Noise Policy shall also be applied to the measured noise levels where<br />
applicable.<br />
b) Noise from the development is to be measured at 1 metre from the dwelling<br />
façade to determine compliance with the L A1(1 minute) noise limits in the above<br />
table.<br />
c) The noise emission limits identified in the above table apply under<br />
meteorological conditions <strong>of</strong>:<br />
• Wind speeds <strong>of</strong> up to 3 m/s at 10 metres above ground level; or<br />
• Temperature inversion conditions <strong>of</strong> up to 3ºC/100m, and wind speeds <strong>of</strong><br />
up to 2 m/s at 10 metres above ground level.<br />
12