Regional Haul Model Operator's Manual - Peterbilt Motors Company
Regional Haul Model Operator's Manual - Peterbilt Motors Company Regional Haul Model Operator's Manual - Peterbilt Motors Company
OPTIONAL GAUGES Press In For Washer Pump Rotate To Change Wiper Mode Press Button For ID and Clearance Lights Flash If your ID and clearance lights are on, they will flash off. Windshield Wipers/Washer Your vehicle is equipped with a two-speed, intermittent windshield wiper system. A seven-position rotary wiper switch (located on the turn signal lever) operates the windshield wipers and washer (see next illustration). Rotate the end of the turn signal lever to change the wiper mode. NOTE: The ignition key must be turned to ON or ACC for the wiper/washer switches to operate. The first position after OFF is the intermittent #1 cycle. The next positions are intermittent #2, #3, and #4. The last CONTROLS AND DISPLAY two positions are wiper low speed and wiper high speed. See the wiper switch settings table that follows for intermittent delay times. WARNING! Clean blades regularly with a damp cloth to remove road film and wax build-up. Do not drive with worn or dirty wiper blades. They can reduce visibility, making driving hazardous which may lead to an injury accident resulting in death or personal injury. CAUTION: • Do not use antifreeze or engine coolant in the windshield washer reservoir—damage to seals and other components will result. If the electric pump is operated for a long period (more than 15 seconds) with a dry reservoir, the pump motor may be damaged. To Wash The Windshield Push the rotary wash/wipe knob in (towards steering column), hold for more than 0.8 seconds and then release. Hold the knob in to extend the washing cycle. After the lever is released, the wipers will shut off automatically or resume the wiper’s setting speed. – 46 – Y53-6033 Regional Haul (R05/10)
CONTROLS AND DISPLAY OPTIONAL GAUGES Wiper Switch Settings High Wiper Switch Settings High Speed Wiper Switch Position Off Intermittent #1 Intermittent #2 Intermittent #3 Intermittent #4 Low Wiper Speed Off 20 Second Delay 17 Second Delay 7 Second Delay 4 Second Delay Low Speed To activate the wipers for one swipe without activating the washer (“mist” function), push the turn signal lever in (towards the steering column) and release in less than 0.5 seconds. The wipers will perform a single swipe and then resume the wiper’s setting speed. Check the windshield washing fluid level daily. If necessary, fill to top. Clean all inside and outside windows regularly. Use an alcohol-based cleaning solution and wipe dry with either a lint-free or a chamois cloth. Avoid running the wiper blades over a dry windshield to prevent scratching the glass. Spray on washer fluid first. A scratched windshield will reduce visibility. Electric Horn Your Peterbilt has an electric horn. To operate, press on the horn symbol near the center of the steering wheel. Regional Haul (R05/10) Y53-6033 – 47 –
- Page 1 and 2: Y53-6033-RegionalHual-FrontCover.ai
- Page 3 and 4: Other Publications Order either of
- Page 5 and 6: INTRODUCTION HOW TO USE THIS MANUAL
- Page 7 and 8: INTRODUCTION Vehicle Safety Make su
- Page 9 and 10: INTRODUCTION Shop Manuals If you do
- Page 11 and 12: CAB AND FRAME ACCESS INTRODUCTION C
- Page 13 and 14: CAB AND FRAME ACCESS CAB AND FRAME
- Page 15 and 16: ENGINE ACCESS Put one hand on the h
- Page 17 and 18: ENGINE ACCESS HOOD HOLD DOWNS AND T
- Page 19 and 20: CONTROLS AND DISPLAYS INSTRUMENTS A
- Page 21 and 22: CONTROLS AND DISPLAYS INSTRUMENTS A
- Page 23 and 24: CONTROLS AND DISPLAYS INSTRUMENTS A
- Page 25 and 26: CONTROLS AND DISPLAYS Warning Light
- Page 27 and 28: CONTROLS AND DISPLAYS Warning Light
- Page 29 and 30: CONTROLS AND DISPLAYS 9. Cruise Con
- Page 31 and 32: CONTROLS AND DISPLAYS injury. 20. E
- Page 33 and 34: CONTROLS AND DISPLAYS 32. Seat Belt
- Page 35 and 36: CONTROLS AND DISPLAYS • MCS butto
- Page 37 and 38: CONTROLS AND DISPLAYS - Trip Idle P
- Page 39 and 40: CONTROLS AND DISPLAYS INSTRUMENTS A
- Page 41 and 42: CONTROLS AND DISPLAY STANDARD GAUGE
- Page 43 and 44: CONTROLS AND DISPLAY Engine Oil Pre
- Page 45 and 46: CONTROLS AND DISPLAY CAUTION: Keep
- Page 47 and 48: CONTROLS AND DISPLAY OPTIONAL GAUGE
- Page 49: CONTROLS AND DISPLAY operate the si
- Page 53 and 54: CONTROLS AND DISPLAY See “Brake S
- Page 55 and 56: CONTROLS AND DISPLAY DASH- AND DOOR
- Page 57 and 58: CONTROLS AND DISPLAY ID and Clearan
- Page 59 and 60: CONTROLS AND DISPLAY WARNING! Do no
- Page 61 and 62: CONTROLS AND DISPLAY DASH- AND DOOR
- Page 63 and 64: CONTROLS AND DISPLAY closed or open
- Page 65 and 66: CONTROLS AND DISPLAY DASH- AND DOOR
- Page 67 and 68: CONTROLS AND DISPLAY WARNING! Do no
- Page 69 and 70: CONTROLS AND DISPLAY •If you are
- Page 71 and 72: CONTROLS AND DISPLAY CIGARETTE LIGH
- Page 73 and 74: CONTROLS AND DISPLAY SHIFT PATTERN
- Page 75 and 76: CONTROLS AND DISPLAY NOTE: The map
- Page 77 and 78: SEATS SAFETY RESTRAINT BELTS CHUGGE
- Page 79 and 80: SEATS • Belts should fit snugly a
- Page 81 and 82: SEATS Safety Restraint Tips NOTE: P
- Page 83 and 84: SEATS Komfort-Lok® Latch Your Pete
- Page 85 and 86: DRIVER'S CHECKLIST SAFE VEHICLE OPE
- Page 87 and 88: DRIVER'S CHECKLIST GAWR: is the Gro
- Page 89 and 90: DRIVER'S CHECKLIST 7. Steps and Han
- Page 91 and 92: STARTING AND OPERATING THE VEHICLE
- Page 93 and 94: STARTING AND OPERATING THE VEHICLE
- Page 95 and 96: STARTING AND OPERATING THE VEHICLE
- Page 97 and 98: STARTING AND OPERATING THE VEHICLE
- Page 99 and 100: STARTING AND OPERATING THE VEHICLE
CONTROLS AND DISPLAY<br />
OPTIONAL GAUGES<br />
Wiper Switch Settings<br />
High<br />
Wiper Switch Settings<br />
High Speed<br />
Wiper Switch Position<br />
Off<br />
Intermittent #1<br />
Intermittent #2<br />
Intermittent #3<br />
Intermittent #4<br />
Low<br />
Wiper Speed<br />
Off<br />
20 Second Delay<br />
17 Second Delay<br />
7 Second Delay<br />
4 Second Delay<br />
Low Speed<br />
To activate the wipers for one swipe without activating the<br />
washer (“mist” function), push the turn signal lever in<br />
(towards the steering column) and release in less than 0.5<br />
seconds. The wipers will perform a single swipe and then<br />
resume the wiper’s setting speed.<br />
Check the windshield washing fluid level daily. If necessary,<br />
fill to top.<br />
Clean all inside and outside windows regularly. Use an<br />
alcohol-based cleaning solution and wipe dry with either a<br />
lint-free or a chamois cloth. Avoid running the wiper<br />
blades over a dry windshield to prevent scratching the<br />
glass. Spray on washer fluid first. A scratched windshield<br />
will reduce visibility.<br />
Electric Horn<br />
Your <strong>Peterbilt</strong> has an electric horn. To operate, press on<br />
the horn symbol near the center of the steering wheel.<br />
<strong>Regional</strong> <strong>Haul</strong> (R05/10) Y53-6033 – 47 –