Regional Haul Model Operator's Manual - Peterbilt Motors Company
Regional Haul Model Operator's Manual - Peterbilt Motors Company
Regional Haul Model Operator's Manual - Peterbilt Motors Company
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
PREVENTIVE MAINTENANCE<br />
WARNING! To avoid death, serious personal<br />
injury and damage to the vehicle, heed all<br />
warnings and instructions of the jumper cable<br />
manufacturer.<br />
• The jumper cables must be long enough so<br />
that the vehicles do not touch.<br />
If either battery has vent caps, remove them and check<br />
the fluid level. If it is OK, replace the caps before going<br />
further. If the level is low, add distilled water and replace<br />
the caps before proceeding. If no water is available,<br />
remove the caps and cover the filler openings with a cloth.<br />
After jump starting the vehicle, dispose of the cloth.<br />
WARNING! If you do not cover the filler openings<br />
on the battery, electrolyte could boil out<br />
of the openings and cause death, injury or<br />
damage the vehicle. Replace caps securely if<br />
the battery has the full level of electrolyte. If<br />
the electrolyte is low and no water is available,<br />
cover with a cloth.<br />
Preparing the vehicles:<br />
1. Position the two vehicles together, but do not let them<br />
to touch.<br />
ELECTRICAL SYSTEM<br />
2. Turn OFF all lights, heater, radio, and any other<br />
accessory.<br />
3. Set the parking brakes: pull out the Yellow button<br />
located on the dash.<br />
4. Shift the transmission into park position. (See Pages<br />
95 and 101 for transmission shifting and parking<br />
brake information.)<br />
5. Turn engine OFF (booster vehicle).<br />
6. Disconnect ground cable on booster battery.<br />
Connect the batteries:<br />
WARNING! When connecting jumper cables,<br />
make sure they can not get caught in any<br />
moving parts in the engine compartment. You<br />
could be killed or seriously injured.<br />
1. Attach one end of a jumper cable to the positive terminal<br />
of the discharged (dead) battery. This will have a<br />
large red “+” or “P” on the battery case, post, or<br />
clamp.<br />
2. Attach the other end of the same cable to the positive<br />
(+) terminal of the good (booster) battery.<br />
<strong>Regional</strong> <strong>Haul</strong> (R05/10) Y53-6033 – 219 –