Peterbilt ComfortClass Operator's Manual - Peterbilt Motors Company

More documents

Recommendations

Info

The Peterbilt ComfortClass System PART 1: INTRODUCTION System features include: • Engine-off sleeper heating, cooling, and 120-Volt AC power. • No engine noise or vibration. • Decrease in overall fuel consumption. Figure -12 i NOTE: This system is NOT designed to cool a hot sleeper. Use the vehicle’s air conditioner to pre-cool the sleeper to at least 75°F prior to turning on the ComfortClass System air conditioner. The system can then be used to maintain that temperature. Figure -13 i NOTE: The system is designed to maintain the interior sleeper temperature around 75°F for a period of up to 10 hours * , based on maximum outside temperature of 95°F, a relative humidity of 50%, and with the sleeper not in direct sunlight. The sleeper environment must be pre-cooled to 75°F by the air conditioner prior to use of the system. The system is NOT designed to maintain sleeper temperatures under extremes of heat or direct sunlight. You may need to supplement the ComfortClass System by operating the vehicle’s air conditioner if the ComfortClass System is unable to maintain the desired temperature level. * Overall performance may vary depending on conditions described on page 33. This Operator’s Manual contains useful information for the safe and efficient operation of your ComfortClass System. All information contained in this manual is based on the latest production information available at the time of publication. Peterbilt Motors reserves the right to make changes at any time without notice. – 4 – Y53-6017 R(09/07)
PART 1: INTRODUCTION The Peterbilt ComfortClass System Location of Components Figure 1 Fuel-Fired Heater (in passenger’s side toolbox) Air Handler (Under Lower Bunk) Enhanced Insulation High Output Alternator Starter Batteries Disconnect Switch Air Conditioning Charge Unit ComfortClass System Battery Disconnect Switch Shore Power Connector ComfortClass System Battery Box Starter Batteries Circuit Breaker Box (located in driver’s side toolbox) Storage Cooler (Behind Sleeper) ComfortClass System Batteries PB00001 Figure 2 R(09/07) Y53-6017 – 5 –
Page 1: Quick Table of Contents Introductio
Page 4 and 5: Safety Signals PART 1: INTRODUCTION
Page 8 and 9: The Peterbilt ComfortClass System P
Page 10 and 11: Charging/Jump-Starting Instructions
Page 16 and 17: 12-Volt DC System 12-Volt DC System
Page 18 and 19: 12-Volt DC System PART 2: ELECTRIC
Page 20 and 21: Shore Power PART 2: ELECTRIC POWER
Page 28 and 29: Controls and Switches PART 3: HEATI
Page 30 and 31: Using the Heater PART 3: HEATING AN
Page 32 and 33: Using the Heater Step 3: If you wan
Page 34 and 35: Using the Air Conditioner PART 3: H
Page 36 and 37: Using the Air Conditioner PART 3: H
Page 38 and 39: Cooling System Components PART 3: H
Page 40 and 41: Cooling System Components PART 3: H
Page 42 and 43: Preventative Maintenance PART 3: HE
Page 44: PART 4: TROUBLESHOOTING Concern Pos

Peterbilt ComfortClass Operator's Manual - Peterbilt Motors Company

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?