Peterbilt ComfortClass Operator's Manual - Peterbilt Motors Company

More documents

Recommendations

Info

Using the Air Conditioner PART 3: HEATING AND AIR CONDITIONING SYSTEM Figure -113 i Figure -114 i NOTE: This system is NOT designed to cool a hot sleeper. Use the vehicle’s air conditioner to pre-cool the sleeper to at least 75°F prior to turning on the ComfortClass System air conditioner. The system can then be used to maintain that temperature. NOTE: The system is designed to maintain the interior sleeper temperature around 75°F for a period of up to 10 hours * , based on maximum outside temperature of 95°F, a relative humidity of 50%, and with the sleeper not in direct sunlight. The sleeper environment must be pre-cooled to 75°F by the air conditioner prior to use of the system. The system is NOT designed to maintain sleeper temperatures under extremes of heat or direct sunlight. You may need to supplement the ComfortClass System by operating the vehicle’s air conditioner if the ComfortClass System is unable to maintain the desired temperature level. * Overall performance may vary depending on conditions described on page 33. For maximum cooling ability: • The sleeper compartment should already be at a maximum 75°F temperature using the cab A/C system. • The window covers and sleeper curtain should be in place and closed. • The Fresh/Recirculation Air Switch should be in the RECIRCULATION position. • The Temperature Control Dial of the sleeper should be in the green band. • The dust and pollen filter must be clean and clear of dust and pollen. • The truck must be parked in shade out of direct sunlight. – 34 – Y53-6017 R(09/07)
PART 3: HEATING AND AIR CONDITIONING SYSTEM Cooling System Components Cooling System Components Cooling Vents Storage Cooler Figure -117 Figure -115 Storage Cooler Output Vent PB00024 Coolant Reservoir Storage Cooler Figure -116 The ComfortClass System has one dedicated air vent. This vent is separate from the vents used for the vehicle’s HVAC system. PB00026 Figure -118 R(09/07) Y53-6017 – 35 –
Page 1: Quick Table of Contents Introductio
Page 4 and 5: Safety Signals PART 1: INTRODUCTION
Page 6 and 7: The Peterbilt ComfortClass System P
Page 8 and 9: The Peterbilt ComfortClass System P
Page 10 and 11: Charging/Jump-Starting Instructions
Page 16 and 17: 12-Volt DC System 12-Volt DC System
Page 18 and 19: 12-Volt DC System PART 2: ELECTRIC
Page 20 and 21: Shore Power PART 2: ELECTRIC POWER
Page 28 and 29: Controls and Switches PART 3: HEATI
Page 30 and 31: Using the Heater PART 3: HEATING AN
Page 32 and 33: Using the Heater Step 3: If you wan
Page 34 and 35: Using the Air Conditioner PART 3: H
Page 38 and 39: Cooling System Components PART 3: H
Page 40 and 41: Cooling System Components PART 3: H
Page 42 and 43: Preventative Maintenance PART 3: HE
Page 44: PART 4: TROUBLESHOOTING Concern Pos

Peterbilt ComfortClass Operator's Manual - Peterbilt Motors Company

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?