Peterbilt ComfortClass Operator's Manual - Peterbilt Motors Company

More documents

Recommendations

Info

Using the Heater PART 3: HEATING AND AIR CONDITIONING SYSTEM Using the Heater Figure -88 Figure -89 Figure -90 Figure -91 WARNING! Do not operate the sleeper heating system or ventilating system around hazardous fumes or exhaust gases. Hazardous fumes and exhaust fumes may be vented into the sleeper compartment causing serious illness that may lead to death. Do not park your vehicle near other vehicles that are idling or where other hazardous fumes may be present. WARNING! Do not operate the heater portion of the <strong>ComfortClass</strong> System when vehicle is in an enclosed, unventilated area. Exhaust fumes from the air heater contain carbon monoxide, a colorless and odorless gas which, if inhaled, can cause serious illness that may lead to death. Never park in an enclosed area when operating the heater. Figure -92 Figure -93 i Figure -94 WARNING! Exhaust fumes from the heating unit contain carbon monoxide, a colorless and odorless gas. Do not breathe the heater exhaust gas. A poorly maintained, damaged, or corroded exhaust system can allow carbon monoxide to enter the cab or sleeper. Entry of carbon monoxide into the cab or sleeper is also possible from other vehicles nearby. Failure to properly maintain your vehicle could cause carbon monoxide to enter the cab/sleeper and cause serious illness that may lead to death. NOTE: When filling fuel tanks with low-temperature fuel, run the air heater for 15 minutes in warmer climates to circulate the low-temperature fuel into the heater system to prevent the fuel from gelling in colder climates. – 28 – Y53-6017 R(09/07)
PART 3: HEATING AND AIR CONDITIONING SYSTEM Using the Heater Follow the steps to properly start and operate the heater. Figure -95 Figure -98 Heating Mode Red Bands Heat ON Position Air Conditioning/Heating Switch PB00016 Temperature Control Dial PB00017 Figure -96 Step 1: Turn the Air Conditioning/Heating Switch to the Heater ON position. Figure -97 i NOTE: A flashing RED lamp indicates a system fault. Contact the nearest authorized repair facility. Figure -99 Step 2: Turn the Temperature Control Dial clockwise to the Heating Mode. Turning the dial in a clockwise direction (red band on dial) increases both the temperature and the Fuel-Fired Heater fan speed simultaneously. Turn the knob clockwise to increase the temperature or counterclockwise to decrease the temperature. Once the desired temperature is reached, the system will maintain it automatically. The dial is not calibrated to specific temperatures. R(09/07) Y53-6017 – 29 –
Page 1: Quick Table of Contents Introductio
Page 4 and 5: Safety Signals PART 1: INTRODUCTION
Page 6 and 7: The Peterbilt ComfortClass System P
Page 8 and 9: The Peterbilt ComfortClass System P
Page 10 and 11: Charging/Jump-Starting Instructions
Page 16 and 17: 12-Volt DC System 12-Volt DC System
Page 18 and 19: 12-Volt DC System PART 2: ELECTRIC
Page 20 and 21: Shore Power PART 2: ELECTRIC POWER
Page 28 and 29: Controls and Switches PART 3: HEATI
Page 32 and 33: Using the Heater Step 3: If you wan
Page 34 and 35: Using the Air Conditioner PART 3: H
Page 36 and 37: Using the Air Conditioner PART 3: H
Page 38 and 39: Cooling System Components PART 3: H
Page 40 and 41: Cooling System Components PART 3: H
Page 42 and 43: Preventative Maintenance PART 3: HE
Page 44: PART 4: TROUBLESHOOTING Concern Pos

Peterbilt ComfortClass Operator's Manual - Peterbilt Motors Company

Create successful ePaper yourself

Delete template?

Save as template?