MODEL 330 OPERATOR'S MANUAL - Peterbilt Motors Company

Using the Brake System
the parking brake valve will not hold in the release position
until the system pressure exceeds 60 psi (414 kPa), which is
the pressure required to override the load of this valve’s
plunger return spring.
Trailer Supply Valve (tractor): The Red octagonal-shaped
knob protects the tractor system; it functions in conjunction
with the parking brake valve (yellow). The trailer supply valve
is responsible for synchronizing the tractor and trailer parking
and emergency brakes. If the air system is being charged
from zero pressure, the trailer supply valve will not hold in the
applied position until the system pressure exceeds 50 psi
(345 kPa). It automatically pops out and exhausts air if supply
air pressure drops below 60 psi (414 kPa).
Tractor Protection Valve: The functions of this valve are to
(1) receive all pneumatic signals pertinent to the operation of
the trailer brake system, (2) transmit these signals to the
trailer, and (3) protect the tractor air supply in case of separation
of the air lines connecting the tractor to the trailer.
Hydraulic Brakes
Introduction
Operating Instructions
The operation of the vehicle’s braking system is based on the
principle of hydraulics. Hydraulic action begins when force is
applied to the brake pedal. This force creates hydraulic pressure
in the master cylinder and is amplified with assistance of
a power booster. The supplemental boost in force is developed
when pressurized power steering fluid from the steering
pump presses on the master cylinder piston. As a safety precaution,
the pressurized fluid from the master cylinder has
two mutually independent circuits. The primary circuit supplies
the front wheels while the secondary circuit supplies the
rear wheels. The displaced fluid from the master cylinder
travels through brake pipes terminating at the wheel cylinders
which actuate the brake pad mechanisms. Actuation of
these mechanisms force the brake pads against the rotors to
stop the wheels.
A reserve electric motor pump provides a redundant power
source for the hydraulic booster in the event normal flow from
the power steering pump is interrupted. Manual braking is
also available in the event both the power and reserve systems
are inoperative.
– 86 – PB1318 3/01 Model 330