MODEL 330 OPERATOR'S MANUAL - Peterbilt Motors Company
MODEL 330 OPERATOR'S MANUAL - Peterbilt Motors Company
MODEL 330 OPERATOR'S MANUAL - Peterbilt Motors Company
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Preventive Maintenance<br />
• Never use a fast charger as a booster to start the engine.<br />
This can seriously damage sensitive electronic components<br />
such as relays, radio, etc., as well as the battery<br />
charger. Fast charging a battery is dangerous and<br />
should only be attempted by a competent mechanic with<br />
the proper equipment.<br />
Slow Battery Charging<br />
NOTE: Follow the instructions that come with your<br />
battery charger.<br />
• It is not necessary to remove the battery from the compartment.<br />
WARNING! Charger cables must be connected<br />
positive to positive (+ to +) and negative to negative<br />
(– to –). If connected improperly, batteries<br />
could explode causing serious personal injury.<br />
• Always make sure the battery charger is OFF before<br />
connecting or disconnecting the cable clamps. To<br />
reduce the danger of explosions and resulting serious<br />
personal injury, do not connect or disconnect<br />
charger cables while the charger is operating.<br />
Electrical System<br />
1. Make sure the electrolyte level in each cell is between<br />
the “MIN” and “MAX” marks. If the fluid level is below the<br />
“MIN” mark, correct the condition.<br />
2. Disconnect the battery cables.<br />
3. Connect charger cables.<br />
4. Start charging the battery at a rate not over 6 amperes.<br />
Normally, a battery should be charged at no more than<br />
10 percent of its rated capacity.<br />
5. After charging, turn OFF charger and disconnect charger<br />
cables.<br />
Bulb Replacement<br />
Tail Lights<br />
To replace the tail lamps, remove lens. The bulbs are all of<br />
the bayonet type.<br />
1. To remove the bulbs, turn bayonet counter clockwise and<br />
pull out.<br />
2. To install, fit the bulb in the socket, push in and turn bayonet<br />
clockwise.<br />
Model <strong>330</strong> PB1318 3/01 – 193 –