MODEL 330 OPERATOR'S MANUAL - Peterbilt Motors Company

Preventive Maintenance
Follow the procedure below to check the compressed air
system for leaks:
1. Periodically, or after maintenance or replacement of air
system components:
2. Build up air pressure in the system to the governor cutout
point or until 120 psi (827 kPa) is reached.
3. Stop the engine and release the service brakes.
4. Without applying the brake pedal, observe the rate of air
pressure drop. This rate should not exceed 2.0 psi (14
kPa) per minute.
5. Start the engine and build up the air pressure again.
6. Stop the engine, and apply the brakes fully. Apply the
brake pedal and hold it down for five minutes. The pressure
drop should not exceed 3.0 psi (21 kPa) per minute.
7. If you detect excessive leakage (air pressure loss greater
than 3.0 psi after five minutes of brake application), a
leakage test should be made at the air line connections
and at all air brake control units. These tests should
determine where air is escaping.
Air Compressor
Operation
Air System
All compressors, regardless of make or model, run continuously
while the engine is running. System pressure is controlled
by the governor. The governor acts in conjunction with
the unloading mechanism in the compressor cylinder block to
start and stop compression of air. The compressor is
unloaded when the system pressure reaches 120 psi (827
kPa) and compression is re-established when system pressure
falls to 100 psi (690 kPa).
Preventive Maintenance
The following service checks are provided for your information
only and should be performed by a certified mechanic.
Contact your Peterbilt Dealer or consult the Medium Duty
Maintenance Manual and the engine manufacturer’s Maintenance
Manual for further information on servicing air compressors.
After completing any repairs to the air system, always test for
air leaks, and check the brakes for safe operation before putting
the vehicle in service.
Model 330 PB1318 3/01 – 167 –