MODEL 330 OPERATOR'S MANUAL - Peterbilt Motors Company
Share Embed Flag
Download ePaper

MODEL 330 OPERATOR'S MANUAL - Peterbilt Motors Company

MODEL 330 OPERATOR'S MANUAL - Peterbilt Motors Company MODEL 330 OPERATOR'S MANUAL - Peterbilt Motors Company

peterbilt.com
from peterbilt.com More from this publisher
20.05.2014 Views

Maintenance Schedule and Lubrication Preventive Maintenance Table 3 Maintenance Schedule INTERVAL COMMENTS OPERATION \ FREQUENCY 7,500 mi 12,000 km 15,000 mi 24,000 km 60,000 mi 96,000 km Governor and Pump Security Seals OK High Idle: ________ rpm Emergency Shutdown Vibration Damper Condition Drain Water from Fuel System Engine Oil – Change Oil Filters – Replace Fuel Filters – Replace Engine Tune–up C2 Cranking System: Visual Inspect./Loose Connections Starter Draw: _________ volts Alternator/Charging System: Visual Inspection/Loose Connections Output Voltage: _________ volts UNDER VEHICLE A B C Steering Components – Condition: Steering Gear Steering Shaft Splines and Joint(s) Pitman Arm Drag Link Steering Arms Tie Rod Arms Tie Rod Ends 25,000 Mile Change Interval – Must Meet Engine Co. Requirements – 128 – PB1318 3/01 Model 330

Preventive Maintenance Maintenance Schedule and Lubrication Table 3 Maintenance Schedule INTERVAL COMMENTS OPERATION \ FREQUENCY Radius Rods / Torque Arms Chassis Frame – Cracks or Breaks Spring Shackles and Hanger Brackets Spring Pins King Pin Wear Steer Axle Wheel Bearing - End Play Adjustment and Inspection Front Hub Lubricant Level Spring Leaves 7,500 mi 12,000 km No Service Required No Service Required 350,000 Miles With LMS Outer Ends • No Leak – No Service Tighten U-bolts after the first 500 miles U–Bolt and Suspension Fastener Torque (800 km). Rear suspension fasteners: retorque after first 2,000 miles (3218 km). Leaks: Coolant Engine Oil Power Steering Fuel Transmission Axles Inner and Outer Hub Seals Engine and Transmission Mounts Drivelines – U–joints and Slip Yokes Rear Axle Lubricant Level Rear Axle Lubricant Flush & Refill C4 At 250,000 Miles Rear Axle Breathers – Clear Tractor Protection Valve Breakaway Test Model 330 PB1318 3/01 – 129 – 15,000 mi 24,000 km 60,000 mi 96,000 km

Preventive Maintenance<br />

Maintenance Schedule and Lubrication<br />

Table 3<br />

Maintenance Schedule<br />

INTERVAL<br />

COMMENTS<br />

OPERATION \ FREQUENCY<br />

Radius Rods / Torque Arms<br />

Chassis Frame – Cracks or Breaks<br />

Spring Shackles and Hanger Brackets<br />

Spring Pins<br />

King Pin Wear<br />

Steer Axle Wheel Bearing - End Play Adjustment<br />

and Inspection<br />

Front Hub Lubricant Level<br />

Spring Leaves<br />

7,500 mi<br />

12,000 km<br />

No Service Required<br />

No Service Required<br />

350,000 Miles With LMS Outer Ends<br />

• No Leak – No Service<br />

Tighten U-bolts after the first 500 miles<br />

U–Bolt and Suspension Fastener Torque<br />

(800 km). Rear suspension fasteners:<br />

retorque after first 2,000 miles (3218 km).<br />

Leaks:<br />

Coolant<br />

Engine Oil<br />

Power Steering<br />

Fuel<br />

Transmission<br />

Axles<br />

Inner and Outer Hub Seals<br />

Engine and Transmission Mounts<br />

Drivelines – U–joints and Slip Yokes<br />

Rear Axle Lubricant Level<br />

Rear Axle Lubricant Flush & Refill C4 At 250,000 Miles<br />

Rear Axle Breathers – Clear<br />

Tractor Protection Valve Breakaway Test<br />

Model <strong>330</strong> PB1318 3/01 – 129 –<br />

15,000 mi<br />

24,000 km<br />

60,000 mi<br />

96,000 km

logo

products

Resources

Company

Terms of service
Privacy policy
Cookie policy
Cookie settings
Imprint
Change language
Made with love in Switzerland
© 2024 Yumpu.com all rights reserved

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!