Peterbilt Medium Duty Truck Owner's Manual - Peterbilt Motors

CAB AND FRAME ACCESS
Cab and Frame Access
Introduction
The following section covers procedures for accessing the
cab and the frame.
Door Lock and Keys
Doors can be locked from the inside by using the lock button.
Close the door then push the button down to lock.
Doors automatically unlock when you open them from
inside, and can be locked from the outside with the key
only.
As standard equipment, two keys are provided for the
doors and ignition. When necessary, additional locks and
keys are provided for storage compartments.
WARNING! To help lessen the chance and/or
severity of death or personal injury in case of
an accident, always lock the doors while driving.
Along with using the lap shoulder belts
properly, locking the doors helps prevent
doors from inadvertently opening and occupants
from being ejected from the vehicle.
To lock or unlock the doors from outside the cab:
• Insert the key in the door lock.
• Turn the key toward the rear door frame to lock; forward
to unlock.
Cab and Frame Access
The following cab and frame entry/exit procedure recommendations
were prepared with personal safety foremost
in mind.
WARNING! Do not jump out of the cab or get
into the cab without proper caution. You could
slip or fall, possibly suffering death or serious
injury. You could slip and fall if the steps are
wet or icy, or if you step in fuel, oil, grease,
snow or mud.
To help avoid personal injury due to a slip or fall:
• ALWAYS FACE TORWARDS THE CAB AND USE THREE
POINTS OF CONTACT (TWO FEET, ONE HAND OR ONE
FOOT, TWO HANDS) TO GRIP THE STEPS OR HANDHOLDS
WHENEVER POSSIBLE AND LOOK WHERE YOU ARE GOING.
Medium Duty (R05/09) Y53-6027 – 9 –