Peterbilt Medium Duty Truck Owner's Manual - Peterbilt Motors
Peterbilt Medium Duty Truck Owner's Manual - Peterbilt Motors
Peterbilt Medium Duty Truck Owner's Manual - Peterbilt Motors
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Preventive Maintenance<br />
To Jump Start Your Vehicle<br />
WARNING! The voltage of the booster battery<br />
must have a 12–volt rating. And the capacity of<br />
the booster battery should not be lower than<br />
that of the discharged battery. Use of batteries of<br />
different voltage or substantially different capacity<br />
rating may cause an explosion and death or<br />
serious personal injury.<br />
CAUTION: Applying a higher voltage booster<br />
battery will cause expensive damage to sensitive<br />
electronic components, such as relays, and<br />
the radio.<br />
•Improper hook-up of jumper cables or not following<br />
these procedures can damage the alternator<br />
or cause serious damage to both vehicles.<br />
WARNING! To avoid death, serious personal<br />
injury and damage to the vehicle, heed all warnings<br />
and instructions of the jumper cable manufacturer.<br />
•The jumper cables must be long enough so that<br />
the vehicles do not touch.<br />
If either battery has vent caps, remove them and check the<br />
fluid level. If it is OK, replace the caps before going further. If<br />
the level is low, add distilled water and replace the caps<br />
Electrical System<br />
before proceeding. If no water is available, remove the caps<br />
and cover the filler openings with a cloth. After jump starting<br />
the vehicle, dispose of the cloth.<br />
WARNING! If you do not cover the filler openings<br />
on the battery, electrolyte could boil out of the<br />
openings and cause death, injury or damage the<br />
vehicle. Replace caps securely if the battery has<br />
the full level of electrolyte. If the electrolyte is<br />
low and no water is available, cover with a cloth.<br />
Preparing the vehicles:<br />
1. Position the two vehicles together, but do not let them to<br />
touch.<br />
2. Turn OFF all lights, heater, radio, and any other accessory.<br />
3. Set the parking brakes: pull out the Yellow button<br />
located on the dash.<br />
4. Shift the transmission into park position. (See Pages 67<br />
and 34 for transmission shifting and parking brake information.)<br />
5. Turn engine OFF (booster vehicle).<br />
6. Disconnect ground cable on booster battery.<br />
<strong>Medium</strong> <strong>Duty</strong> (R05/09) Y53-6027 – 223 –