Peterbilt Model 320 Operator's Manual after 8-07 - Peterbilt Motors ...
Peterbilt Model 320 Operator's Manual after 8-07 - Peterbilt Motors ...
Peterbilt Model 320 Operator's Manual after 8-07 - Peterbilt Motors ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
PART 8: MAINTENANCE AND SERVICE<br />
Inspection & Maintenance Instructions for Noise Control System<br />
Diesel Particulate Filter (DPF)<br />
Use only an exact replacement DPF in exhaust systems.<br />
Using a noncompliant DPF as a replacement could violate<br />
these standards and also void the emission system’s warranty.<br />
NOTE: Check the DPF for looseness.<br />
loose mounting bolts as necessary.<br />
Exhaust Tail Pipe(s)<br />
Tighten<br />
Check the mounting security. Tighten as necessary. The<br />
miter cut at the tip of the pipe must be facing the rear of the<br />
truck. Do not modify the end of the pipe in any way..<br />
Fan Shroud<br />
WARNING! The engine fan can engage at any<br />
time without warning. Anyone near the fan<br />
when it turns on could be badly injured. Before<br />
turning on the ignition, be sure that no one is<br />
near the fan. Do not work on the fan with the<br />
engine running.<br />
Check all fasteners for tightness. Check for stress cracks<br />
in the shroud. Make sure the shroud is adjusted so that it<br />
does not touch the fan blades.<br />
Engine Mounted Noise Insulators<br />
Fasteners<br />
Check for condition and security. How you do this will depend<br />
on the method of attaching the noise insulators on<br />
the engine and around the oil pan (bolts, snap fasteners,<br />
or straps). Tighten loose fasteners; repair or replace any<br />
worn or damaged fasteners.<br />
Insulators<br />
Check insulators around fasteners and stress points, especially<br />
where they may be affected by engine vibration.<br />
Repair any cracked or damaged mounting points. Use suitable<br />
reinforcing plates to ensure that the insulators will remain<br />
in position.<br />
Inner Fender Shields and Cab Skirts<br />
Fasteners<br />
Check all fasteners for security, especially the self-tapping<br />
hex head screws. Remove and replace any loose rivets.<br />
R(08/<strong>07</strong>) Y53-6015 – 193 –