Peterbilt Model 320 Operator's Manual after 8-07 - Peterbilt Motors ...
Peterbilt Model 320 Operator's Manual after 8-07 - Peterbilt Motors ...
Peterbilt Model 320 Operator's Manual after 8-07 - Peterbilt Motors ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Fuel Filters<br />
WARNING! A mixture of gasoline or alcohol with<br />
diesel fuel in the presence of an ignition source<br />
(such as a cigarette) could cause an explosion.<br />
You could be seriously injured. Use only the<br />
recommended diesel fuel.<br />
CAUTION: If anyone ever pours gasoline into<br />
your fuel tank, drain the entire system. Otherwise,<br />
the pump and engine will be damaged.<br />
Don’t try to dilute the gasoline by adding diesel<br />
fuel (See Warning above).<br />
Fuel Filters<br />
Please follow these recommendations when you are<br />
changing your fuel filters or strainer elements. Your engine<br />
will run better and last longer if you do. See the engine<br />
manufacturer’s recommendations for proper water and<br />
micron requirements.<br />
• When removing filters, cover any electrical equipment<br />
and wiring that might get soaked with fuel. Diesel fuel<br />
may permanently damage electrical insulation.<br />
PART 8: MAINTENANCE AND SERVICE<br />
• When installing spin-on (throwaway) filters, hand<br />
tighten them only to 1/2 to 2/3 turn <strong>after</strong> gasket contact.<br />
Mechanical tightening of these filters may distort<br />
or crack the filter head.<br />
NOTE: To expel air from density-type strainer elements,<br />
soak them in clean fuel before installing<br />
them.<br />
• When replacing a fuel filter element, don’t use a substitute.<br />
Install only filter elements designed for fuel filtration.<br />
First clean and inspect the shell. Then insert<br />
the new element and fill the container at least 2/3 full<br />
of clean fuel before installing the shell.<br />
• Throw away old gaskets. Replace them with new ones<br />
to ensure a positive seal.<br />
• Position the shell and gasket properly. Then tighten<br />
the cover nut or bolt just enough to prevent fuel leakage.<br />
• After starting the engine, check for leaks around the<br />
filter.<br />
– 176 – Y53-6015 R(08/<strong>07</strong>)