Peterbilt Model 320 Operator's Manual after 8-07 - Peterbilt Motors ...
Peterbilt Model 320 Operator's Manual after 8-07 - Peterbilt Motors ...
Peterbilt Model 320 Operator's Manual after 8-07 - Peterbilt Motors ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Battery Care<br />
damage to the vehicle, heed all warnings<br />
and instructions of the jumper cable manufacturer.<br />
The jumper cables must be long<br />
enough so that the vehicles do not touch.<br />
• Applying a higher voltage booster battery will<br />
cause expensive damage to sensitive electronic<br />
components, such as relays, and the<br />
radio. Improper hook–up of jumper cables<br />
or not following these procedures can damage<br />
the alternator or cause serious damage<br />
to both vehicles or yourself.<br />
• Battery posts, terminals, and related accessories<br />
contain lead and lead compounds,<br />
chemicals known to the State of California to<br />
cause cancer and reproductive harm. Wash<br />
hands <strong>after</strong> handling.<br />
CAUTION: Departures from these procedures<br />
could also cause serious damage to both vehicles.<br />
Improper use of a booster battery to start<br />
a vehicle may cause an explosion.<br />
To Jump Start Your Vehicle:<br />
1. Wear eye protection and remove rings, metal watch<br />
bands, and any other metal jewelry.<br />
PART 8: MAINTENANCE AND SERVICE<br />
2. Set the parking brakes. Place the transmissions of<br />
both vehicles in Neutral. Do not let the vehicles touch<br />
one another. Turn the ignition key to Off in the vehicle<br />
with the discharged battery. Also turn off lights, heater,<br />
and any other unnecessary electrical load.<br />
3. If either battery has vent caps, remove them and check<br />
the fluid level. If it is OK, replace the caps before going<br />
further. If the level is low, add distilled water, and replace<br />
the caps before proceeding. If no water is available,<br />
remove the caps and cover the filler openings<br />
with a cloth before proceeding. After jump starting the<br />
vehicle, dispose of the cloth.<br />
WARNING! If you do not cover the filler openings<br />
on the battery, electrolyte could boil out<br />
of the openings and hurt someone or damage<br />
the vehicle. Replace caps securely if there<br />
is enough fluid in the battery, or cover with<br />
a cloth if no water is available and your fluid<br />
is low.<br />
4. Attach one end of a jumper cable to the dead battery’s<br />
positive terminal. This will have a large red “+” or “P”<br />
on the battery case, post, or clamp. Attach the other<br />
end of the same cable to the positive terminal of the<br />
good battery.<br />
– 174 – Y53-6015 R(08/<strong>07</strong>)