IntelliTouch Expansion Center Installation Guide - Pentair

More documents

Recommendations

Info

8 5. Strip back the cable conductors ¼ inch. Insert the wires into the either of the COM PORTS (J7 and J8) screw terminals located on the left side of the Personality board. Secure the wires with the screws. Make sure to match the color-coding of the wires: GND = Black, Green = -DT, Yellow = +DT, and Red = +15 (see diagram below). For wiring details, refer to the Wiring Diagram for models i5x and i10x (page 10). Note: Multiple wires may be inserted into a single screw terminal. 6. Close the Expansion enclosure Outdoor Control Panel and secure it with the two access screws. 7. If removed, install the high voltage panel cover and secure it with the two retaining screws. Personality Board (Left-side) Note: COM Ports can also be used for connection to IntelliChlor and IntelliFlo Personality Board Feed each relay cable plug up through holes IntelliTouch Expansion Center Kit Installation Guide
9 Connecting the Expansion Center Transformer To connect the Expansion Center transformer wire harness onto the Personality board: • Connect the transformer plug onto connector J2 on the right side of Personality board. The plug is keyed onto the pins so that the six wires point towards back of the board. From left to right the wire colors should be blue, orange, red. For the connector location, refer to the diagram shown below and the System Wiring Diagram (page 10). Note: The transformer terminals can be wired 115 VAC or 230 VAC. Refer to the System Wiring Diagram for models i5x and i10x (see page 10 for wiring connections). Affixing the System Wiring Diagram Label To affix the wiring diagram label on the Expansion Center inside front door: 1. Open the Expansion Center front door. 2. Peel the backing off the wiring diagram label. 3. Position the label in middle of the inside of the front door. Apply even pressure on the surface of the label to secure in place. IntelliTouch Expansion Center Kit Installation Guide
Page 1 and 2: pool/spa control system IntelliTouc
Page 3 and 4: i Contents IMPORTANT SAFETY PRECAUT
Page 5 and 6: iii IMPORTANT SAFETY PRECAUTIONS (C
Page 7 and 8: 1 IntelliTouch Expansion Center Kit
Page 9 and 10: 3 Installing Conduit and Wire • R
Page 11 and 12: 5 Connecting the Expansion Center P
Page 13: Connecting the Expansion Unit to th
Page 17 and 18: 11 Glossary Expansion Kit: A kit th
Page 20: P/N 520471 - Rev A

IntelliTouch Expansion Center Installation Guide - Pentair

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?