Intelliflo VF Installation / Owners Manual - Pool Center

More documents

Recommendations

Info

36 Blank Page IntelliFlo VF Installation and User’s Guide
37 Section 4 User Maintenance The following information describes how to service and maintain the IntelliFlo pump. Pump Strainer Basket The strainer, sometimes referred to as the “Hair and Lint Pot,” is in front of the of the pump. Inside there is a basket which must be kept clean of leaves and debris at all times. View the basket through the top see through lid to inspect for leaves and debris. Regardless of the length of time between filter cleaning, it is most important to visually inspect the hair and lint pot basket at least once a week. A dirty basket will reduce the efficiency of the filter and possibly the heater. WARNING — DO NOT open the strainer pot if pump fails to prime or if pump has been operating without water in the strainer pot. Pumps operated in these circumstances may experience a build up of vapor pressure and may contain scalding hot water. Opening the pump may cause serious personal injury. In order to avoid the possibility of personal injury, make sure the suction and discharge valves are open and that the strainer pot is cool to the touch, then open with extreme caution. CAUTION — To prevent damage to the pump and filter and for proper operation of the system, clean pump strainer and skimmer baskets regularly. Pump Strainer Basket Service If the IntelliFlo pump is installed below the water level of the pool, close the return and suction lines before opening the hair and lint pot on the pump. 1. Place the IntelliFlo in “Manual” mode. Press the Start/Stop button to stop the pump and switch off the pump at the circuit breaker. 2. Disconnect the communication cable from the IntelliFlo pump. 3. Relieve pressure in the system. 4. Turn the clamp and lid in a counterclockwise direction until it stops. 5. Remove the clamp and lid. 6. Remove the basket and put the debris into the trash and rinse out the basket. If the basket is cracked, replace the basket. 7. Replace the basket and fill the pump pot and volute with water up to the inlet port. 8. Clean the cover, O-ring, and sealing surface of the pump pot. Grease the O-ring with Teflon or silicone lubricant. 9. Reinstall the lid by placing the clamp and the lid on the pot. IntelliFlo VF Installation and User’s Guide
Page 1 and 2: IntelliFlo ® VF Variable Flow Pump
Page 3 and 4: i Contents Important Safety Precaut
Page 5 and 6: F iii IMPORTANT SAFETY PRECAUTIONS
Page 7 and 8: v IMPORTANT SAFETY PRECAUTIONS (con
Page 9 and 10: IntelliFlo ® VF Overview 1 Section
Page 11 and 12: 3 Operator control panel cover Driv
Page 13 and 14: This section describes the operator
Page 15 and 16: 7 Navigating the Menu Structure Bef
Page 17 and 18: This section describes how to use t
Page 19 and 20: 11 Manual Mode (Continued) 9. Press
Page 21 and 22: 13 Pool Data Mode Use the Pool Data
Page 23 and 24: 15 Priming Mode (Continued) 6. To s
Page 25 and 26: 17 Filter Mode (Continued) 5. To se
Page 27 and 28: 19 Filter Mode (Continued) Clean Fi
Page 29 and 30: 21 Filter Mode (Continued) Flow Con
Page 31 and 32: 23 Features Mode The Feature mode c
Page 33 and 34: 25 Features Mode (Continued) The fu
Page 35 and 36: 27 3. To enable Feature 3: Press th
Page 37 and 38: 29 External Control with IntelliCom
Page 39 and 40: 31 Controlling IntelliFlo with the
Page 41 and 42: 33 Backwash Mode When the Filter mo
Page 43: 35 Vacuum Mode Use Vacuum mode to c
Page 47 and 48: 39 Winterizing The IntelliFlo’s i
Page 49 and 50: Section 5 Installation and Removal
Page 51 and 52: 43 Pump Disassembly WARNING — Alw
Page 53 and 54: 45 Drive Assembly Removal and Insta
Page 55 and 56: 12.50 47 IntelliFlo VF Pump Dimensi
Page 57 and 58: Alerts and Warnings The IntelliFlo
Page 59 and 60: 51 IntelliFlo VF Installation and U
Page 61 and 62: 53 How to make your pool more energ
Page 63 and 64: 55 Notes IntelliFlo VF Installation
Page 65 and 66: Notes

Intelliflo VF Installation / Owners Manual - Pool Center

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?