Intelliflo VF Installation / Owners Manual - Pool Center
Intelliflo VF Installation / Owners Manual - Pool Center
Intelliflo VF Installation / Owners Manual - Pool Center
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
20<br />
Filter Mode (Continued)<br />
Using Filter mode with Features mode<br />
IntelliFlo will start and stop at programmed filter cycles 1-4. The filter cycles can be overridden by<br />
“Feature” (3-9 only) as shown in the example below. This may cause the required filter volume to be<br />
achieved earlier.<br />
The “Feature” function is allowed to take control during “Filter” mode. When the feature function stops,<br />
IntelliFlo will continue in “Filter” mode. If only Feature 3-9 is active during a filter cycle, IntelliFlo will<br />
calculate a new filter cycle.<br />
Example: The IntelliFlo was suppose to run in Filter mode from 1:00 to 11:00 to turnover<br />
10 GPM for 10 hours (10 GPM 10 Hours= 6 kGal).<br />
But because Feature 3 has been running 20 GPM for 4 hours (20 GPM 4 Hours= 4,8 kGal),<br />
the IntelliFlo must stop at 8:00 because; 10 GPM* 3 Hours + 20 GPM 4 Hours= 6,6 kGal.<br />
20 GPM<br />
Flow<br />
10 GPM<br />
Filter<br />
Cycle 1<br />
Feature 3<br />
1 4 8 11<br />
Time<br />
“Feature” 1 and 2 do not have time-of-day functions and do not affect the filter cycle time. The active time<br />
for “Feature” 1 and 2 will not be calculated into the reduced cycle time as shown in the above example.<br />
IntelliFlo <strong>VF</strong> <strong>Installation</strong> and User’s Guide