Intelliflo VF Installation / Owners Manual - Pool Center
Intelliflo VF Installation / Owners Manual - Pool Center
Intelliflo VF Installation / Owners Manual - Pool Center
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
7<br />
Navigating the Menu Structure<br />
Before navigating the control panel menu structure, first familiarize yourself with the menu buttons. To<br />
change a parameter setting, use the Left and Right arrow buttons to select the digit, then the Up and Down<br />
arrow buttons to edit the digit. The following example shows how to set the GPM and priming time in the<br />
“Priming” menu (see page 14).<br />
Priming Mode Example<br />
To set the “Priming” mode settings:<br />
1. Ensure that the green power LED is on and the pump is stopped.<br />
If the pump is running, press the Start/Stop button.<br />
Start<br />
Stop<br />
Menu<br />
2. Press the Menu button. “<strong>Pool</strong> Data” is displayed.<br />
Menu<br />
3. Press the Down arrow to select “Priming”.<br />
Select<br />
4. Press the Select button to access “Max Priming Flow” setting.<br />
Select<br />
5. Set the GPM: Press the Select button to set the gallons per minute<br />
(GPM) value.<br />
Select<br />
Select<br />
6. To change the GPM value, press the Left and Right arrows to select<br />
which digit to modify.<br />
Press the Up and Down arrows to change the selected digit. For setting<br />
values, see “Priming menu options” below.<br />
7. When you are done, press the<br />
Enter<br />
Enter button to save the changes. To<br />
cancel any changes.<br />
Press the<br />
Escape<br />
Escape button to exit edit mode without saving.<br />
5X<br />
8. Set the priming time: Use the Up and Down arrows to select “Max<br />
Priming Time” and “System Priming Time.”<br />
Enter<br />
Press the<br />
Select<br />
Select to edit the setting.<br />
9. Repeat steps 5, 6, and 7 to edit the setting.<br />
Escape<br />
IntelliFlo <strong>VF</strong> <strong>Installation</strong> and User’s Guide