Best Practices for Project Management, Design, and Construction of ...

More documents

Recommendations

Info

Existing Conditions New additions and renovations to existing buildings may need additional information for accessibility that goes beyond the immediate scope of the project. This information may include the location of accessible toilets that serve the new addition or area of renovation; details of existing elevators, ramps, and stairways that provide access to the new addition or area of renovation; and exterior descriptions of the accessible route of travel from bus stops and dedicated parking stalls. (OSHPD Best Practices) Page 34 DRAFT FINAL, Sept. 2011
3.6 Door Schedule Purpose The door schedule provides the essential information for the reviewers to determine compliance with required egress widths and rated assemblies, as well as detailed information for the contractors to coordinate the construction of walls, finishes, and hardware. Organization and Approach Traditionally, there are several ways to document door information. One way includes providing width and ratings information directly on the plans; another includes referencing the door to a schedule or spreadsheet that lists all the pertinent information for the door types and hardware. Except in the smallest or simplest of projects, it is recommended that a schedule format be used. OPENING NO. RATING OPENING SIZE DOOR FRAME HDWRE GROUP TYPE MAT. GLASS TYPE MAT. DTL. NO. NOTES 100A 20S 4-0”x7’-0” A1 WD - F1 HM 12/A9.2 36 CARD READER 101A 60M PR 4-0”x7’-0” A3 WD GL-1 F5 HM 23/A9.2 20 101B - 3-0”x7’-0” B1 HM - H2 HM 15/A9/2 17 Drawing Content The door schedule must provide as its basic information the rating of the door and frame assembly commensurate with the wall rating and the door's function. The function of the wall rating may be part of a one-hour corridor, a two-hour stair or exit passageway enclosure, a one-hour smoke compartment wall, or a rated occupancy separation wall. Rating requirements for openings in each of these wall conditions are provided in various sections of the CBC. In addition to the door rating in minutes (e.g., 20, 45, 60, or 90 min), the schedule must indicate for the reviewer whether the door is required to be "tight-fitting smoke-and draft-control assemblies" typically with an "S" designation (e.g., 20S, 60S, etc.). Some doors may also be required to have a specified temperature rating, using a "T" designation in the door schedule. Other door features that may be indicated in the door schedule for the reviewer's information include required door hardware such as panic devices, closers, view windows, etc. The required width of the door is determined both by the occupant load assigned to pass through the door for exiting and by the specific requirements of its location within the hospital. Every (OSHPD Best Practices) Page 35 DRAFT FINAL, Sept. 2011
Page 1 and 2: [On inside Title Page: Many of the
Page 3 and 4: • Part 1 of Title 24 is the Calif
Page 5 and 6: Rapid Review Unit The Rapid Review
Page 7 and 8: Section 2: Geologic Hazards Investi
Page 9 and 10: equested, CGS will review the suppl
Page 11 and 12: under OSHPD regulations. Please see
Page 13 and 14: Another approach to creating better
Page 15 and 16: create confusion. The discipline ha
Page 17 and 18: applicable phasing must be clearly
Page 19 and 20: addresses, and project Websites, ma
Page 21 and 22: • Plumbing fixture counts for pub
Page 23 and 24: (OSHPD Best Practices) Page 23 DRAF
Page 25 and 26: • Treatment of listed floor slab
Page 27 and 28: • References to the prescriptive
Page 29 and 30: Provisions of California Fire Code
Page 31 and 32: Existing Special Conditions The sam
Page 33: Enlarged Drawings Provide enlarged
Page 37 and 38: Existing or Special Conditions Exis
Page 39 and 40: approved “shake table testing.”
Page 41 and 42: Drawing Content Equipment may inclu
Page 43 and 44: Drawing Content For details that pr
Page 45 and 46: Details that provide information on
Page 47 and 48: Early in the design process, it is
Page 49 and 50: • Identify any equipment that req
Page 51 and 52: • Identify any equipment that req
Page 53 and 54: Several drawings contain essential
Page 55 and 56: o o o o o o o o Floor Plan - Lighti
Page 57 and 58: Section 4: Inspector of Record Best
Page 59 and 60: • Approved program flexes; • Ra
Page 61 and 62: 9. The IOR shall submit verified co
Page 63 and 64: • Log and record areas that by de
Page 65 and 66: • Inspections completed by the us
Page 67 and 68: Logging Inspection Requests 1. When
Page 69 and 70: Preconstruction Meetings A preconst
Page 71 and 72: • Explain code requirements for s
Page 73 and 74: Concluding Remarks An IOR needs to
Page 75 and 76: Although including the TIO Program
Page 77 and 78: Owner The Owner is responsible for
Page 79 and 80: Inspections The TIO Program should
Page 81 and 82: The construction of hospitals in Ca
Page 83 and 84: Instruction Bulletins (IBs), prepar
Page 85 and 86:
Changes will undoubtedly be require
Page 87 and 88:
Proper execution of these and the o
Page 89 and 90:
contingencies, that concur with def
Page 91 and 92:
and help in determining the cause o
Page 93 and 94:
have discovered that bids only cove
Page 95 and 96:
Best Practice 7: Determine whether
Page 97 and 98:
OSHPD believes the key to receiving
Page 99 and 100:
the design assistance from the manu
Page 101 and 102:
Permit Phase Best Practice 15: Keep
Page 103 and 104:
Comment and Process Review The deci
Page 105 and 106:
See Section 4 of this volume for a
Page 107 and 108:
• OSHPD shall schedule a final st
Page 109 and 110:
CPC CPR DD Deferred Submittals DSE
Page 111:
(OSHPD Best Practices) Page 111 DRA
show all

Best Practices for Project Management, Design, and Construction of ...

Create successful ePaper yourself

Delete template?

Save as template?