Pantera SA 2M30 - Frame Grabbers

Pantera SA DS -21-02M30 and DS-22-02M30 User’s Manual 62
Command
Description
Syntax Parameters Description
display output LUT dol i i Retrieve and display the contents of
the output LUT where the first
parameter, i, is the first address to be
read out in a range from 0 to 1023
and the second parameter, i, is the
last address to be read out in a range
from 0 to 1023.
See Appendix C for more information
on using look up tables.
Parameters:
i = integer
f = float
t = tap selector
q = window sequence
[ ]= optional parameter
enable input LUT eil i Enable or disable the input LUTs.
When disabled, the video path is
routed around the active LUTs, but
the set values remain unchanged
where i is:
0: Disable input LUT, default
1: Enable input LUT
See Appendix C for more information
on using look up tables.
enable output LUT eol i Enable or disable the output LUTs.
When disabled, the video path is
routed around the active LUTs, but
the set values remain unchanged
where i is:
0: Disable input LUT, default
1: Enable input LUT
See Appendix C for more information
on using look up tables.
factory LUT mode flm i Loads a factory calibrated LUT where
i is:
0: User LUT mode. Disable factory
LUTs.
1: 0dB gain
2: 6dB gain
3: 12dB gain
See Appendix C for more information
on using look up tables.
get camera id gci Read the camera ID
get camera model gcm Read the camera model number
get camera parameters gcp Read all of the camera parameters.
Note: Sequence of camera parameters
may change as new functionality is
added to the camera. When possible,
use commands specific to the
information you want to retrieve
get camera serial gcs Read the camera serial number
get camera version gcv Read the firmware version and FPGA
version
get sensor serial gss Read the sensor serial number
DALSA 03-32-10150-01